Fan speed control
Press the fan control buttons to manually control the fan speed.
Press the AUTO button to return to automatic control of the fan speed.
Air recirculation
Press the air recirculation button to recirculate interior air inside the vehicle. The indicator light on the button will come on.
The air recirculation cannot be activated when the air conditioner is in the front defrosting mode.
Fresh air intake
Press the fresh air intake button to draw outside air into the passenger compartment.
The indicator light on the button will come on.
Air flow control
Pressing the MODE button manually controls air flow and selects the air outlet:
— Air flows mainly from center
and
side vents.
— Air flows mainly from center and
side vents and foot outlets.
— Air flows mainly from foot
outlets
and partly from defroster.
— Air flows mainly from defroster
and
foot outlets.
To turn system off
Press the OFF button.
Rear window and outside mirror (if so equipped) defroster button
For additional information, refer to “Rear window and outside mirror (if so equipped) defroster switch” in the “Instruments and controls” section of this manual.
B terminal circuit
Description
Terminal “B” is constantly supplied with battery power.
Diagnosis Procedure
Regarding Wiring Diagram information, refer to STR-7, "Wiring Diagram".
CAUTION:
Perform diagnosis under the condition that the engine cannot start by the
following procedure.
Remov ...
Input speed sensor
Exploded View
Input speed sensor
O-ring
Transaxle assembly
: Always replace after every
disassembly.
: N·m (kg-m, in-lb)
: Apply CVT fluid
Removal and Installation
REMOVAL
Remove battery tray. Refer to TM-207, "Removal and Installation".
Remove the ...
Sensor power supply2 circuit
Description
ECM supplies a voltage of 5 V to some of the sensors systematically divided
into 2 groups, respectively.
Accordingly, when a short circuit develops in a sensor power source, a
malfunction may occur simultaneously
in the sensors belonging to the same group as the short-circuited ...