To make a call from a phone connected to the vehicle’s Bluetooth® Hands-Free Phone System:
Say “Call”.
For 7- and 10-digit phone numbers, speak the numbers. When finished, say “Dial” to initiate the call. Say “Correction” at any time in the process to correct a misspoken or misinterpreted number.
For phone numbers with more digits or special characters, say “Special Number”, then speak the digits. Up to 24 digits can be entered. Available special characters are “star”, “pound”, “plus” and “pause”. When finished, say “Dial” to initiate the call. Say “Correction” at any time in the process to correct a misspoken or misinterpreted number or character.
The name of the phonebook entry will be displayed if it available, otherwise the number being redialed will be displayed.
Receiving a call
When a call is received by the phone connected to the vehicle’s Bluetooth® Hands-Free Phone System, the call information is displayed on either the vehicle information display or both the vehicle information display and the control panel display.
Press the button to accept the call. Press the button to reject the call.
During a call
While a call is active, press the button to access additional options. Speak one of the following commands:
If supported by the phone, the Bluetooth® Hands-Free Phone System allows for call waiting functionality. If a call is received while another call is already active, a message will be displayed on the screen. Press the button to hold the active call and switch to the second call. Press the button to reject the second call.
While the second call is active, pressing the button will allow the same commands that available during any call as well as two additional commands:
Press the button to accept the call. Press the button to reject the call.
Ending a call
To end an active call, press the button
Power outlets
Instrument Panel
12V OUTLETS
The power outlets are for powering electrical
accessories such as cellular telephones. They
are rated at 12 volt, 120W (10A) maximum.
The front and center console power outlets are
powered only when the ignition switch is in the
ACC (if so equipped) or ON po ...
P0441 EVAP control system
DTC Description
DTC DETECTION LOGIC
In this evaporative emission (EVAP) control system, purge flow occurs during
non-closed throttle conditions.
Purge volume is related to air intake volume. Under normal purge conditions
(non-closed throttle), the EVAP
canister purge volume control solenoi ...
P0847 transmission fluid pressure SEN/SW B
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0847
FLUID PRESS SEN/SW B
(Transmission Fluid Pressure Sensor/Switch B
Circuit Low)
When all of the following conditions are satisfied and this sta ...