Nissan Rogue manuals

Nissan Rogue Owners Manual: Liftgate release

WARNING
  •  Always be sure the liftgate has been closed securely to prevent it from opening while driving.
  •  Do not drive with the liftgate open. This could allow dangerous exhaust gases to be drawn into the vehicle. For additional information, refer to “Exhaust gas (carbon monoxide)” in the “Starting and driving” section of this manual.

 

CAUTION
  •  If the power liftgate does not stay open or if the liftgate unexpectedly closes at any time while a continuous warning chime sounds, do not operate the liftgate.

    There may be a pressure loss in one or both of the liftgate gas stays.

    Have the liftgate inspected by a NISSAN dealer.

  •  Do not activate the power liftgate if one or both of the liftgate gas stays are removed. Damage to the liftgate or power liftgate mechanisms may occur.

Liftgate release (manual and power)
Liftgate release (manual and power)

The liftgate release mechanism allows the liftgate to be opened in the event of a discharged battery.

To release the liftgate from the inside of the vehicle, perform the following operations:

  1.  Fold the rear seats down. For additional information, refer to “Folding 3rd row bench (if so equipped)” in the “Safety—seats, seat belts and supplemental restraint system” section of this manual.
  2.  Insert a suitable tool in the access opening.

    Move the release lever to the right. The liftgate will be unlatched.

  3.  Push the liftgate up to open.

NOTE: If you had to open the liftgate using this lever, have your vehicle checked by a NISSAN dealer as soon as possible.

Liftgate position setting

The liftgate can be set to open to a specific height by performing the following:

  1.  Open the liftgate using the request switch or the Intelligent Key.
  2.  Pull the liftgate down to the desired position and hold the liftgate (the liftgate will have some resistance when being manually adjusted).
  3.  While holding the liftgate in position, press and hold the liftgate switch located on the liftgate for approximately 5 seconds or until three beeps are heard.

The liftgate will open to the selected position setting. To change the position of the liftgate, repeat Ste for setting the position of the liftgate.

Power liftgate main switch
Power liftgate main switch The power liftgate operation can be turned on or off by the power liftgate main switch on the instrument panel. When the power liftgate main switch is pushed to t ...

Fuel-filler door
Opener operation Opener operation The fuel-filler lid release is located below the instrument panel. To open the fuel-filler lid, pull the release. To lock, close the fuel-filler lid securely. ...

Other materials:

Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW Work Flow DETAILED FLOW 1.COLLECT THE INFORMATION FROM THE CUSTOMER Get the detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred) using the diagnosis worksheet. >> GO TO 2. 2. ...

P0606 ECM
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P0606 CONTROL MODULE (Control module processor) Malfunction in ECM processor POSSIBLE CAUSE ECM FAIL-SAFE Not applicable DTC CONFIRMATION ...

Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the ...

© 2014-2024 Copyright www.nirogue.com