Nissan Rogue manuals

Nissan Rogue Service Manual: Interior room lamp power supply circuit

Description

Provides the interior room lamp power supply. Also cuts the power supply when the interior room lamp battery saver is activating.

Component Function Check

1.CHECK INTERIOR ROOM LAMP POWER SUPPLY FUNCTION

CONSULT ACTIVE TEST

  1.  Turn power switch ON.
  2.  Turn each interior room lamp ON.
  1.  Select “BATTERY SAVER” of “BCM” active test item.
  2.  With operating the test items, check that each interior room lamp turns ON/OFF.

Off : Interior room lamp OFF
On : Interior room lamp ON

Does each interior room lamp turn ON/OFF? YES >> Interior room lamp power supply circuit is normal.

NO >> Refer to INL-46, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK INTERIOR ROOM LAMP POWER SUPPLY OUTPUT

CONSULT ACTIVE TEST

  1.  Turn power switch OFF.
  2.  Turn power switch ON.
  3.  Select “BATTERY SAVER” of “” active test item.
  4. With operating the test item, check continuity between BCM harness connector and ground.

Check interior room lamp power supply output

Is the inspection result normal? YES >> GO TO 2.

NO >> Replace BCM. Refer to BCS-75, "Removal and Installation" (with Intelligent Key system) or BCS- 135, "Removal and Installation" (without Intelligent Key system).

2.CHECK INTERIOR ROOM LAMP RELAY SIGNAL OPEN CIRCUIT

  1.  Turn power switch OFF.
  2.  Disconnect the BCM connector and room lamp relay.
  3.  Check continuity between BCM harness connector and room lamp relay harness connector.

Check interior room lamp relay signal open circuit

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace harnesses.

3.CHECK INTERIOR ROOM LAMP RELAY POWER SUPPLY CIRCUIT

  1.  Check voltage at room lamp relay harness connector.

Check interior room lamp relay power supply circuit

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace harnesses.

4.CHECK INTERIOR ROOM LAMP RELAY POWER SUPPLY OUTPUT

  1.  Reconnect room lamp relay.
  2. Check voltage at room lamp relay harness connector.

Check interior room lamp relay power supply output

Is the inspection result normal? YES >> GO TO 5.

NO >> Replace room lamp relay.

5.CHECK INTERIOR ROOM LAMP RELAY POWER SUPPLY OUTPUT

  1.  Disconnect he following connectors:
  1.  Check continuity between room lamp relay connector M12 and interior room lamp connector in question.

Check interior room lamp relay power supply output

Is the inspection result normal? YES >> GO TO 6.

NO >> Repair or replace harnesses.

6.CHECK INTERIOR ROOM LAMP RELAY POWER SUPPLY OUTPUT SHORT CIRCUIT

Check continuity between room lamp relay and ground.

Check interior room lamp relay power supply output short circuit

Is the inspection result normal? YES >> Check that each interior lamp has no internal short circuit.

NO >> Repair or replace harnesses.

DTC/circuit diagnosis
...

Interior room lamp control circuit
Description Controls each interior room lamp (ground side) by PWM signal. NOTE: PWM signal control period is approximately 250 Hz (in the gradual brightening/dimming). Component Function Check ...

Other materials:

Diagnosis and repair workflow
Work Flow OVERALL SEQUENCE DETAILED FLOW 1. OBTAIN INFORMATION ABOUT SYMPTOM Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred. >> GO TO 2. 2. CONFIRM CONCERN Check the malfunction on the veh ...

Wiring diagram
BCM Wiring Diagram ...

Removal and installation
GENERATOR Exploded View REMOVAL Cylinder head Generator bracket Washer  Generator Water pump Cylinder block Removal and Installation REMOVAL  Disconnect negative terminal from battery. Refer to PG-75, "Exploded View".  Remove wheel and tire ...

© 2014-2022 Copyright www.nirogue.com