Nissan Rogue manuals

Nissan Rogue Service Manual: Inspection and adjustment

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement

INITIALIZATION PROCEDURE

Moonroof

If the moonroof does not open or close automatically, use the following procedure to return moonroof operation to normal.

  1.  Turn ignition switch ON.
  2.  Push and hold the moonroof switch forward until the moonroof and sunshade stop and bounce back.
  3.  Release the moonroof switch.
  4.  Press and hold the moonroof switch within 6 seconds.
  5.  The roof glass and shade will move to full open and back to full close.
  6. Release the switch, initialization is complete if the moonroof operates normally.

ANTI-PINCH FUNCTION

Moonroof/Sunshade

  1.  Fully open the moonroof to the full open position.
  2.  Place a piece of wood at the fully closed position.
  3.  Close the moonroof completely with auto-slide close function.
  4.  Moonroof should make contact and then tilt up or travel in reverse.

CAUTION: • Do not test the anti-pinch function with your hands or other body parts because they may be pinched.

• Depending on the environment and driving conditions, if a similar impact or load is applied to the moonroof it may lower.

• Test the auto-slide operation before inspection when the initialization procedure is performed.

• Perform the initialization procedure when the auto-slide operation or anti-pinch function does not operate normally.

Diagnosis and repair workflow
Work Flow OVERALL SEQUENCE DETAILED FLOW 1. OBTAIN INFORMATION ABOUT SYMPTOM Interview the customer to obtain as much information as possible about the conditions and environment under whic ...

Dtc/circuit diagnosis
...

Other materials:

Oil pan and oil strainer
Exploded View Oil pan, upper  Oil filter  Front cover  O-ring  Oil strainer  Oil pan, lower  Washer Drain plug O-ring  Oil level gauge guide Oil level gauge  Rear cover plate  To Oil pan, lower Removal and In ...

P0506 ISC system
Description The ECM controls the engine idle speed to a specified level through the fine adjustment of the air, which is let into the intake manifold, by operating the electric throttle control actuator. The operating of the throttle valve is varied to allow for optimum control of the engine ...

LATCH (Lower Anchors and Tethers for CHildren) System
LATCH system lower anchor locations - bench seat Your vehicle is equipped with special anchor points that are used with LATCH system compatible child restraints. This system may also be referred to as the ISOFIX or ISOFIX compatible system. With this system, you do not have to use a vehicl ...

© 2014-2025 Copyright www.nirogue.com