Description
The ID of the tire pressure sensor installed in each wheel cannot be registered in the tire pressure monitoring system. Inspect the tire pressure sensor or the tire pressure monitoring system circuit.
Diagnosis Procedure
1.CHECK TIRE PRESSURE SENSOR ACTIVATION TOOL
Check tire pressure sensor activation tool.
Is the inspection result normal? YES >> GO TO 2.
NO >> Replace the battery of tire pressure sensor activation tool or repair/replace the tire pressure sensor activation tool.
2.TIRE PRESSURE SENSOR ID REGISTRATION
Perform tire pressure sensor ID registration. Refer to WT-21, "Work Procedure"
CAUTION: To perform ID registration, observe the following points:
Is tire pressure sensor ID registration completed? YES >> Inspection End.
NO >> GO TO 3.
3.CHECK TIRE PRESSURE SIGNAL
Change the work location and perform ID registration again.
NOTE: Depending on the tire pressure sensor position*, a blind spot exists, and the tire pressure receiver gets poor reception. If an ID registration is performed under this condition, the registration may not be completed. In such case, follow the instructions below to improve the radio wave receiving environment.
*: Radio wave reception condition depends on vehicle architecture (e.g. body harness layout, tire wheel design) or environment.
When ID registration is performed, which wheels do not react? All wheels react and ID registration is possible.>>Inspection End.
Only certain wheel(s) do not react.>>Replace applicable tire pressure sensor. Refer to WT-61, "Removal and Installation".
All wheels do not react.>>Replace BCM. Refer to BCS-75, "Removal and Installation" (with Intelligent Key System) or BCS-135, "Removal and Installation" (without Intelligent Key System).
Windshield wiper and washer switch
WARNINGIn freezing temperatures the washer solution
may freeze on the window and obscure
your vision which may lead to an
accident. Warm the window with the defroster
before you wash the window.
CAUTION
Do not operate the washer continuously
for ...
Break-in schedule
CAUTIONDuring the first 1,200 miles (2,000 km),
follow these recommendations to obtain
maximum engine performance and ensure
the future reliability and economy of your
new vehicle. Failure to follow these recommendations
may result in shortened
engine life and reduced engine ...
P0117, P0118 ECT sensor
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P0117
ECT SEN/CIRC
(Engine coolant temperature sensor 1 circuit
low)
An excessively low voltage from the engine coolant temperature
sensor i ...