Nissan Rogue manuals

Nissan Rogue Owners Manual: Fuel gauge

Fuel gauge
Fuel gauge

The gauge indicates the approximate fuel level in the tank.

The gauge may move slightly during braking, turning, acceleration, or going up or down hills.

The gauge needle returns to 0 (Empty) after the ignition switch is placed in the OFF position.

The low fuel warning light comes on when the amount of fuel in the tank is getting low.

Refill the fuel tank before the gauge registers 0 (Empty).

The indicates that the fuel-filler door is located on the driver’s side of the vehicle.

CAUTION
  •  If the vehicle runs out of fuel, the Malfunction Indicator Light (MIL) may come on. Refuel as soon as possible.

    After a few driving trips. the light should turn off. If the light remains on after a few driving trips, have the vehicle inspected by a NISSAN dealer.

  •  For additional information, refer to “Malfunction Indicator Light (MIL)” in this section.
Engine coolant temperature gauge
Engine coolant temperature gauge The gauge indicates the engine coolant temperature. The engine coolant temperature is within the normal range 1 when the gauge needle points within the zone ...

Warning/indicator lights and audible reminders
Anti-lock Braking System (ABS) warning light Brake warning light Charge warning light Low tire pressure warning light Low windshield w ...

Other materials:

Unit disassembly and assembly
CENTER CONSOLE ASSEMBLY Exploded View Center console cup holder (without heated seats)  Coin tray insert  Center console cup holder (with heated seats)  Front heated seat switch (RH) Front heated seat switch (LH) Shift selector finisher  Shift selector ...

Symptom diagnosis
THE SPORT MODE INDICATOR LAMP DOES NOT TURN ON Description The SPORT mode indicator lamp does not turn ON when the SPORT mode switch is operated. Diagnosis Procedure 1.CHECK SPORT MODE INDICATOR LAMP FUNCTION Perform combination meter self-diagnosis mode and check test order 10. Refer to MW ...

Key switch signal circuit (without intelligent key)
Description Transmits a key switch signal to the BCM. Component Function Check 1. CHECK BCM INPUT SIGNAL Select "Data Monitor" for "BCM" and check the "KEY ON SW" monitor value. Is the inspection result normal? YES >> Inspection End. NO >> Refer ...

© 2014-2025 Copyright www.nirogue.com