Nissan Rogue Service Manual: Front grille
Exploded View
- Front bumper fascia
- Front camera (if equipped)
- Front grille
- Front emblem
Pawl
Clip
Removal and Installation
REMOVAL
- Remove front grille upper clip (A) (LH/RH).
- Release clips and pawls, then remove front grille.: Clip
: Pawl
- Disconnect harness connector (A) from front camera (if equipped).
- Remove the following parts after removing front grille (if necessary).
- Front camera (if equipped). Refer to AV-388, "Removal and Installation".
- Front emblem
INSTALLATION
Installation is in the reverse order of removal.
NOTE: Calibration must be performed after removing/replacing the front camera (if equipped). Refer to AV-292, "CALIBRATING CAMERA IMAGE (AROUND VIEW MONITOR) : Work Procedure".
Rear bumper
Exploded View
Rear bumper fascia side bracket
(LH)
Rear mud protector
Rear bumper reinforcement support
(LH)
Rear bumper fascia undercover
(LH)
Rear bumper reinforcement
...
Cowl top
Exploded View
Cowl top side trim cover (RH)
Cowl top cover screen
Cowl top cover seal
EPT seal
Cowl top cover plug
Cowl top cover
Cowl top cover mask
Cowl top ex ...
Other materials:
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT
PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the
...
Removal and installation
A/C SWITCH ASSEMBLY
Removal and Installation
REMOVAL
Release the A/C switch assembly clips and pawls using a suitable
tool.
: Metal clip
: Pawl
Disconnect the harness connector from the A/C switch assembly
(1) and remove.
INSTALLATION
Installation is in the reve ...
Service data and specifications (SDS)
General Specifications
Preload Torque
Drive Gear Runout
Backlash
Differential Side Gear Clearance
...
