Nissan Rogue manuals

Nissan Rogue Service Manual: Front door finisher

Exploded View

Exploded View

  1. Front door
  2. Front door pull handle bracket
  3. Front door pull handle
  4. Front power window switch (RH) finisher
  5. Front door inside handle finisher
  6. Front door finisher

Clip
Pawl

REMOVAL

NOTE: LH shown, RH similar.

  1. Release pawls using a suitable tool (A) from front of inside handle finisher (1) while working toward the rear and remove.

: Pawl

Removal

  1. Release pawls using a suitable tool (A) from front of inside handle finisher (1) while working toward the rear and remove.

: Pawl

Removal

  1. Disconnect harness connector from door mirror remote control switch (LH only).
  2.  Remove bolts (A) and front door inside pull handle bracket (1).

Removal

  1. Release pawls using a suitable tool (A) and remove front door power window and door lock/unlock switch finisher (1).

Removal

  1. Disconnect harness connectors from front door power window and door lock/unlock switch.
  2. Remove front door finisher bolt (A).

Removal

  1. Insert suitable tool (A) between front door finisher and door panel to release clips and pawl, starting from the bottom and working to the top.

: Clip

Removal

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

NOTE: When main power window and door lock/unlock switch or power window door lock/unlock switch RH is removed or replaced, it is necessary to perform the initialization procedure. Refer to PWC-25, "Work Flow".

Removal and installation
...

Rear door finisher
Exploded View Rear door  Rear power window switch finisher  Rear door screw cover  Rear door inside handle finisher Rear door finisher  Tether clip Tether ...

Other materials:

Car phone or CB radio
When installing a CB, ham radio or car phone in your vehicle, be sure to observe the following precautions; otherwise, the new equipment may adversely affect the engine control system and other electronic parts. WARNING  A cellular phone should not be used for any purpose wh ...

Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the ...

U1040 ENG comm circuit
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition U1040 ENG COMM CIRCUIT (Engine communication circuit) ECM cannot transmit a communication signal to generator. POSSIBLE CAUSE  Harne ...

© 2014-2022 Copyright www.nirogue.com