Nissan Rogue Service Manual: Front disc brake
Brake Burnishing
CAUTION:
- Burnish contact surfaces between brake pads and disc brake rotor according to the following procedure after refinishing the disc brake rotor, replacing brake pads or if a soft pedal occurs at very low mileage.
- Be careful of vehicle speed. Brakes do not operate firmly/securely until pads and disc brake rotor are securely seated.
- Only perform this procedure under safe road and traffic conditions. Use extreme caution.
- Drive the vehicle on straight, flat road.
- Depress the brake pedal until the vehicle stops.
- Release the brake pedal for a few minutes to allow the brake components to cool.
- Repeat steps 1 to 3 until pad and disc brake rotor are securely seated.
Brake fluid
Drain and Refill
CAUTION:
Do not spill or splash brake fluid on painted surfaces. Brake
fluid may damage paint. If brake fluid is
splashed on painted areas, wash it away with water imm ...
Rear disc brake
Brake Burnishing
CAUTION:
Burnish contact surfaces between brake pads and disc brake
rotor according to the following procedure
after refinishing the disc brake rotor, replacing brake ...
Other materials:
Display on the Control Display - With Parking Assistant:
Parking Assistant
Display on the Control Display
System activated/deactivated
Gray: the system is not
available.
White: the system is available but not
activated.
System is activated.
Parking space search is
active.
The parking operation is
active. The
system takes over the steering.
Parking space search and ...
Drive belts
Exploded view
Generator pulley
Water pump pulley
Drive belt auto-tensioner
Crankshaft pulley
A/C compressor pulley
Drive belt retainer boss
View A
New drive belt range
Possible use range
Indicator (notch)
Checking
WARNING:
Inspect the ...
xOffroad package
Principle
The xOffroad package supports the driver when
driving away from unpaved roads or with reduced
traction. The system offers four different xOffroad
driving modes for selection.
xOffroad driving modes and
levels
The xOffroad driving modes can be selected
based on the ground conditions.
When ...
