Nissan Rogue manuals

Nissan Rogue Service Manual: Front bumper

Exploded View

Exploded View

  1. Front bumper fascia side bracket (RH)
  2. Front bumper reinforcement support (RH)
  3. Front bumper reinforcement
  4. Front energy absorber
  5. Front lower grille
  6. Front fog lamp (RH) (if equipped)
  7.  Front bumper fascia
  8. Front bumper fascia finisher (RH) (if equipped)
  9. Front fog lamp finisher (RH) (if equipped)
  10. Front license plate bracket
  11. Front air spoiler
  12. Tow cover
  13.  Front fog lamp finisher (LH) (if equipped)
  14.  Front bumper fascia finisher (LH) (if equipped)
  15.  Front fog lamp (LH) (if equipped)
  16.  Front under cover
  17. Front bumper reinforcement support (LH)
  18.  Front bumper fascia side bracket (LH)

Removal and Installation

REMOVAL

CAUTION: Bumper fascia is made of resin. Use care when handling to prevent damage. Avoid contact with oily substances.

  1.  Remove front grille. Refer to EXT-23, "Removal and Installation".
  2.  Remove front bumper fascia clips (A).

Removal

  1. Remove front bumper fascia clips (A) and screws (B).

Removal

  1. Partially remove front fender protectors (LH/RH). Refer to EXT-28, "FENDER PROTECTOR : Exploded View".
  2. Partially remove front over fender molding. Refer to EXT-30, "FRONT OVER FENDER : Removal and Installation".
  3. Remove front bumper fascia screws (A) (LH/RH).

    (1): Front bumper fascia
    (2): Front over fender molding

Removal

  1. Disconnect fog lamp harness connectors (LH/RH) (if equipped).
  2. Release front bumper fascia pawls from front bumper fascia side brackets (LH/RH) and remove.

CAUTION: When removing front bumper fascia, two people are required to avoid damaging.

  1. Remove front bumper fascia bolts (A) and the front bumper side bracket (1) (LH/RH) (if necessary).

Removal

  1. Remove intelligent key warning buzzer. Refer to DLK-273, "Removal and Installation".
  2.  Release harness connector clips from bumper reinforcement, then remove bumper reinforcement nuts (A) and bumper reinforcement (1) (LH/RH).

Removal

  1. Remove front bumper reinforcement support bolts (A) and front bumper reinforcement supports (1) (LH/RH).

Removal

  1. Remove the following parts (if necessary) after removing front bumper fascia assembly.

INSTALLATION

Installation in the reverse order of removal.

Installation

Installation

Removal and installation
...

Rear bumper
Exploded View Rear bumper fascia side bracket (LH) Rear mud protector Rear bumper reinforcement support (LH)  Rear bumper fascia undercover (LH) Rear bumper reinforcement ...

Other materials:

Front passenger air bag module
Exploded View Front passenger air bag module  Steering member Removal and Installation WARNING:  Before servicing the SRS, turn ignition switch OFF, disconnect both battery terminals then wait at least three minutes. Always work from the side of air bag module. Do ...

Wiring diagram
AUTOMATIC AIR CONDITIONING SYSTEM Wiring Diagram ...

Vehicle information
Identification information Model Variation FWD Model AWD Model Prefix and Suffix Designations Identification Number Air conditioner specification label  Emission control information label  Vehicle identification number chassis number (center of bulkhead) ...

В© 2014-2024 Copyright www.nirogue.com