Nissan Rogue manuals

Nissan Rogue Service Manual: Electrical load signal

Description

The electrical load signal (Headlamp switch signal, rear window defogger switch signal, etc.) is transferred via the CAN communication.

Component Function Check

1.CHECK REAR WINDOW DEFOGGER SWITCH FUNCTION

  1.  Turn ignition switch ON.
  2.  Connect CONSULT and select “DATA MONITOR” mode.
  3.  Select “LOAD SIGNAL” and check indication under the following conditions.

Check rear window defogger switch function

Is the inspection result normal? YES >> GO TO 2.

NO >> Proceed to EC-462, "Diagnosis Procedure".

2.CHECK LIGHTING SWITCH FUNCTION

Check “LOAD SIGNAL” indication under the following conditions.

Check lighting switch function

Is the inspection result normal? YES >> GO TO 3.

NO >> Proceed to EC-462, "Diagnosis Procedure".

3.CHECK HEATER FAN CONTROL SWITCH FUNCTION

Select “HEATER FAN SW” and check indication under the following conditions.

Check heater fan control switch function

Is the inspection result normal? YES >> INSPECTION END

NO >> Proceed to EC-462, "Diagnosis Procedure".

Diagnosis Procedure

1.INSPECTION START

Confirm the malfunctioning circuit (rear window defogger, headlamp or heater fan). Refer to EC-462, "Component Function Check".

Which circuit is related to the incident? Rear window defogger>>GO TO 2.

Headlamp>>GO TO 3.

Heater fan>>GO TO 4.

2.CHECK REAR WINDOW DEFOGGER SYSTEM

Check rear window defogger system. Refer to DEF-19, "Work Flow".

>> INSPECTION END

3.CHECK HEADLAMP SYSTEM

Check headlamp system. Refer to EXL-82, "Work Flow" (with halogen headlamp) or EXL-219, "Work Flow" (with LED headlamp).

>> INSPECTION END

4.CHECK HEATER FAN CONTROL SYSTEM

Check heater fan control system. Refer to HAC-46, "Work Flow" (with automatic air conditioner) or HAC-146, "Work Flow" (with manual air conditioner).

>> INSPECTION END

Cooling fan
Component Function Check 1.CHECK COOLING FAN FUNCTION With CONSULT  Turn ignition switch ON.  Perform “COOLING FAN (DUAL)” in “ACTIVE TEST” mode of “IPDM E/R” using CO ...

Fuel injector
Component Function Check 1.INSPECTION START Turn ignition switch to START. Are any cylinders ignited? YES >> GO TO 2. NO >> Proceed to EC-464, "Diagnosis Procedure". 2. ...

Other materials:

Vehicle jerks during
Description The vehicle jerks when VDC function, TCS function, ABS function, EBD function, Brake limited slip differential (BLSD) function, Brake assist function, hill start assist function or Brake force distribution function operates. Diagnosis Procedure 1.CHECK SYMPTOM Check that the veh ...

C1765, C1766, C1767, C1768 tire pressure sensor
DTC Description DTC DETECTION LOGIC DTC Display Item Malfunction Detected Condition Possible Cause C1765 WHEEL TOP DATA FL (Wheel top data front left) Malfunction in the wheel top data from the front LH wheel speed sensor. Wheel speed sensor C1766 ...

Preparation
Special Service Tool The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description — (J-39570) Chassis Ear Locating the noise — (J-50397) NISSAN Squeak and Rattle Kit ...

© 2014-2024 Copyright www.nirogue.com