Nissan Rogue manuals

Nissan Rogue Service Manual: ECU diagnosis information

A/C AUTO AMP.

Reference Value

VALUES ON THE DIAGNOSIS TOOL

Values on the diagnosis tool

TERMINAL LAYOUT

Terminal layout

PHYSICAL VALUES

Physical values

Physical values

Physical values

Physical values

DTC Inspection Priority Chart

If some DTCs are displayed at the same time, perform inspections one by one based on the following priority chart.

Priority

Detected items (DTC)

1
  • U1000: CAN COMM CIRCUIT
  •  U1010: CONTROL UNIT (CAN)
2
  • B24A9: SUNLOAD SEN
  •  B24A0: A/C AUTO AMP.
  •  B24A1: A/C AUTO AMP. POWER SUPPLY
  •  B24A4: INTAKE TEMP SEN
  •  B24A6: IN-VEHICLE SEN
  •  B24BB: LEFT AIRMIX ACTR
  •  B24BD: RIGHT AIRMIX ACTR
  •  B24B4: A/C CONTROL
  •  B24B6: A/C CONTROL
  •  B24B7: INTAKE ACTR
  •  B24B9: MODE ACTR
  •  B24C3: BLOWER MOTOR FEEDBACK
  •  B24C6: BLOWER MOTOR CONTROL
  •  B24D4: A/C CONTROL COMMUNICATION

DTC Index

DTC Index

DTC Index

*: Perform self-diagnosis under direct sunlight. When performing indoors, aim a light (more than 60 W) at sunload sensor, otherwise selfdiagnosis reports an error even though the sunload sensor is functioning normally.

ECM, IPDM E/R, BCM

List of ECU Reference

List of ECU Reference

System description
Component Part Location RH side of engine compartment  RH front of vehicle (view with front bumper fascia removed)  LH front of vehicle (view with front bumper fascia remove ...

Wiring diagram
AUTOMATIC AIR CONDITIONING SYSTEM Wiring Diagram ...

Other materials:

Seatback pockets
Seatback pockets There is a pocket located on the back of the driver and passenger seats. These pockets can be used to store maps. WARNINGTo ensure proper operation of the passenger’s advanced air bag system, please observe the following items:  Do not allow a pas ...

P117A air fuel ratio
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P117A AIR FUEL RATIO B1 (AIR FUEL RATIO B1) ECM detects a lean/rich air fuel ratio state in any cylinder for a specified length of time. ...

Preparation
Special Service Tools The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description KV10111100 (J-37228) Seal cutter Removing oil pan (lower) etc. Commercial Service Tools T ...

© 2014-2022 Copyright www.nirogue.com