Nissan Rogue Service Manual: Driver air bag module
Exploded View
- Steering wheel
- Driver air bag module
Removal and Installation
WARNING:
- Before servicing the SRS, turn ignition switch OFF, disconnect
both battery terminals then wait at
least three minutes.
- Always work from the side of driver air bag module. Do not work
in front of it.
- Do not use the air tools or electric tools for servicing.
REMOVAL
- Disconnect negative and positive battery terminals, then wait at
least three minutes. Refer to PG-77,
"Removal and Installation".
- Release driver air bag module hooks.
- Locate the access hole on RH side of steering wheel rear finisher
(1) and insert ( ) a 5.0 mm
(0.20 in) diameter suitable tool
(A).
- Push suitable tool (A) inward (
) and make sure the tool contacts
the spring (2) as shown. Push on the upper right of the
driver air bag module while pressing on the spring to release the
driver air bag module hook (RH). Repeat procedure for driver air
bag module hook (LH).
NOTE:
Driver air bag module removed for clarity.
- Lift driver air bag module as shown, then disconnect harness
connectors from the driver air bag module.
CAUTION:
- For installing/removing the driver air bag module harness
connector, insert thin screwdriver wrapped in tape into
notch, lift lock and remove the connector.
- Install the connector with lock raised, and push lock into
the connector.
- After installing the connector, check that the lock is
pushed securely into it.
- Remove the driver air bag module.
CAUTION:
- Always place the driver air bag module with pad side facing
upward.
: Upward
- Do not strike or impact the driver air bag module.
- Replace the driver air bag module if it has been dropped
or sustained an impact.
- Do not insert any foreign objects (screwdriver, etc.) into the driver
air bag module.
- Do not disassemble the driver air bag module.
- Do not expose the driver air bag module to temperatures
exceeding 93°C (199°F).
- Do not allow oil, grease, detergent, or water to come in
contact with the driver air bag module.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
- Always connect the driver air bag module harnesses (A) and
route through the hook (B) as shown.
Exploded View
Combination switch
Steering angle sensor
Spiral cabl
Removal and Installation
WARNING:
Before servicing the SRS, turn ignition switch OFF, disconnect
both ...
Other materials:
Diagnosis system (TCM)
DIAGNOSIS DESCRIPTION
DIAGNOSIS DESCRIPTION : 1 Trip Detection Diagnosis and 2 Trip Detection
Diagnosis
NOTE:
“Start the engine and turn OFF the ignition switch after warm-up.” This is
defined as 1 trip.
1 TRIP DETECTION DIAGNOSIS
When initial malfunction is detected, TCM memorizes DTC. ...
Preparation
Special Service Tool
The actual shape of the tools may differ from those illustrated here.
Tool number
(TechMate No.)
Tool name
Description
—
(J-46534)
Trim Tool Set
Removing trim components
...
Body component parts
Underbody Component Parts
Both sided anti-corrosive
precoated steel portions
High strength steel (HSS)
portions: 440 MPa
Both sided anti-corrosive
steel and HSS portions: 440 MPa
CAUTION:
If the high strength steel (ultra high strength steel) of this is broken,
replace by assem ...
© 2014-2024 Copyright www.nirogue.com