Nissan Rogue Service Manual: Door mirror
Exploded View
- Door mirror
- Door mirror corner finisher
- Door mirror rear finisher
- Side turn signal lamp
- Side camera (if equipped)
- Door mirror glass
Pawl
Removal and Installation
REMOVAL
- Remove front door finisher. Refer to INT-15, "Removal and Installation".
- Release door mirror corner finisher clips using a suitable tool.
- Disconnect the harness connector from the blind spot warning indicator (if equipped), then remove the door mirror corner finisher.
- Disconnect the harness connector from the door mirror.
- Remove door mirror nuts and door mirror.
- Remove screws (A) and side camera (1) (if equipped) (if necessary)
from door mirror rear finisher (2). : Pawl
INSTALLATION
Installation is in the reverse order of removal.
CAUTION: Perform camera image calibration (if equipped with around view camera). Refer to AV-136, "CALIBRATING CAMERA IMAGE (AROUND VIEW MONITOR) : Work Procedure".
Inside mirror
Exploded View
MANUAL ANTI-DAZZLING
Windshield glass
Mirror base
Inside mirror
AUTO ANTI-DAZZLING
Windshield glass
Mirror base
Inside mirror
Inside mirror finish ...
Door mirror glass
Removal and Installation
REMOVAL
Release the metal clips and pawls that retain the door mirror
glass using a suitable tool, disconnect the harness connectors
(A) (if equipped) from the ...
Other materials:
P117A air fuel ratio
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P117A
AIR FUEL RATIO B1
(AIR FUEL RATIO B1)
ECM detects a lean/rich air fuel ratio state in any cylinder for a
specified
length of time.
...
CAN system (type 4)
MAIN LINE BETWEEN IPDM-E AND DLC CIRCUIT
Diagnosis Procedure
1.CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and
loose connection (connector side
an ...
Preparation
Special Service Tool
The actual shape of the tools may differ from those illustrated here.
Tool number
(TechMate No.)
Tool name
Description
KV38100500
( — )
Drift
Installing sensor rotor
a: 80 mm (3.15 in) dia.
b: 60 mm (2.36 in) dia.
KV40 ...
