Nissan Rogue Service Manual: Diagnosis system (BCM) (without intelligent key system)

Nissan Rogue Service Manual / Body exterior, doors, roof & vehicle security / Roof / System description / Diagnosis system (BCM) (without intelligent key system)

COMMON ITEM

COMMON ITEM : CONSULT Function (BCM - COMMON ITEM)

APPLICATION ITEM

CONSULT performs the following functions via CAN communication with BCM.

Direct Diagnostic Mode	Description
Ecu Identification	The BCM part number is displayed.
Self Diagnostic Result	The BCM self diagnostic results are displayed.
Data Monitor	The BCM self diagnostic results are displayed.
Active Test	The BCM activates outputs to test components.
Work support	The settings for BCM functions can be changed.
Configuration	The vehicle specification can be read and saved. The vehicle specification can be written when replacing BCM.
Configuration	The result of transmit/receive diagnosis of CAN communication is displayed.

SYSTEM APPLICATION

BCM can perform the following functions.

System application

RETAINED PWR

RETAINED PWR : CONSULT Function (BCM - RETAINED PWR)

DATA MONITOR

Monitor Item [Unit]	Description
DOOR SW-DR [On/Off]	Indicates condition of front door switch LH.
DOOR SW-AS [On/Off]	Indicates condition of front door switch RH.

Diagnosis system (BCM) (with intelligent key system)

COMMON ITEM COMMON ITEM : CONSULT Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT performs the following functions via CAN communication with BCM. Direct Diagnostic Mode De ...

ECU diagnosis information

...

Other materials:

C1160 DECEL G SEN SET
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1160 DECEL G SEN SET When calibration of yaw rate/side/decel G sensor is not complete. Yaw rate/side/decel G sensor Harness or connector ...

Periodic maintenance
REAR DIFFERENTIAL GEAR OIL Inspection OIL LEAKS Make sure that oil is not leaking from final drive assembly or around it. OIL LEVEL Remove filler plug (1) and check oil level from filler plug mounting hole as shown. CAUTION: Do not start engine while checking oil level. &nbs ...

Combination meter
Reference Value VALUES ON THE DIAGNOSIS TOOL *: DDS (hill descent control) NOTE: Some items are not available according to vehicle specification. TERMINAL LAYOUT PHYSICAL VALUES Fail-safe The combination meter activates the fail-safe control if the CAN communica ...