Nissan Rogue manuals

Nissan Rogue Service Manual: Diagnosis system (BCM) (with intelligent key system)

Nissan Rogue Service Manual / Driver controls / Defogger / System description / Diagnosis system (BCM) (with intelligent key system)

COMMON ITEM

COMMON ITEM : CONSULT Function (BCM - COMMON ITEM)

APPLICATION ITEM

CONSULT performs the following functions via CAN communication with BCM.

Direct Diagnostic Mode

Description

Ecu Identification The BCM part number is displayed.
Self Diagnostic Result The BCM self diagnostic results are displayed.
Data Monitor The BCM input/output data is displayed in real time.
Active Test The BCM activates outputs to test components.
Work support The settings for BCM functions can be changed.
Configuration
  • The vehicle specification can be read and saved.
  •  The vehicle specification can be written when replacing BCM.
CAN Diag Support Mnt The result of transmit/receive diagnosis of CAN communication is displayed.

SYSTEM APPLICATION

BCM can perform the following functions.

System application

REAR DEFOGGER

REAR DEFOGGER : CONSULT Function (BCM - REAR DEFOGGER)

DATA MONITOR

Data monitor

ACTIVE TEST

Active test

WORK SUPPORT

Work support

* : Initial setting

System
System Description SYSTEM DIAGRAM OPERATION DESCRIPTION  When rear window defogger switch is turned ON while ignition switch is ON, the rear window defogger switch transmits rear w ...

Diagnosis system (BCM) (without intelligent key system)
COMMON ITEM COMMON ITEM : CONSULT Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT performs the following functions via CAN communication with BCM. Direct Diagnostic Mode De ...

Other materials:

System description
DESCRIPTION Engine Lubrication System Camshaft (INT)  Chain tensioner Main gallery  Oil pan Oil cooler Balancer unit  Oil pan oil gallery Oil filter (with relief valve) Oil Strainer  Oil pump  Timing chain and balancer unit timing chain ...

EVAP canister filter
Exploded View EVAP canister vent control valve hose Canister drain hose Plug  EVAP canister filter Front Removal and Installation REMOVAL  Disconnect EVAP canister vent control valve hose from EVAP canister filter.  Disconnect canister drain hose from E ...

Stall test
Work Procedure INSPECTION  Check the engine oil level. Replenish if necessary. Refer to LU-7, "Inspection".  Check for leak of the CVT fluid. Refer to TM-190, "Inspection".  Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temp ...

В© 2014-2025 Copyright www.nirogue.com