Nissan Rogue Service Manual: Diagnosis and repair work flow

Nissan Rogue Service Manual / Suspension / Road Wheels & Tires / Basic inspection / Diagnosis and repair work flow

Work Flow

NOTE: The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.

Activate and display TPMS sensor IDs
Display tire pressure reported by the TPMS sensor
Read TPMS DTCs
Register TPMS sensor IDs

1.COLLECT INFORMATION FROM CUSTOMER

Get detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred).

>> GO TO 2.

2.TIRE PRESSURE INSPECTION

Check the tire pressure for all wheels. Refer to WT-65, "Tire Air Pressure".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace tire(s) or wheel(s).

3.CHECK LOW TIRE PRESSURE WARNING LAMP

Check that the low tire pressure warning lamp illuminates for approximately 1 second after the ignition switch is turned ON, then turns OFF.

Does the low tire pressure warning lamp turn OFF? YES >> Inspection End.

NO >> GO TO 4.

4.PERFORM SELF DIAGNOSTIC RESULT

Perform self diagnostic result. Refer to BCS-26, "AIR PRESSURE MONITOR : CONSULT Function (BCM-AIR PRESSURE MONITOR)" (with Intelligent Key System) or BCS-94, "AIR PRESSURE MONITOR : CONSULT Function (BCM-AIR PRESSURE MONITOR)" (without Intelligent Key System).

Are any DTCs displayed? YES >> Refer to BCS-48, "DTC Index". If two or more DTCs are displayed, refer to BCS-47, "DTC Inspection Priority Chart".

NO >> GO TO 5.

5.PERFORM DIAGNOSIS APPLICABLE TO THE SYMPTOM

Perform diagnosis applicable to the symptom. Refer to WT-46, "Symptom Table".

>> GO TO 6.

6.FINAL CHECK

Perform self diagnostic result again, and check that the malfunction is repaired. After checking, erase the self diagnosis memory. Refer to BCS-26, "AIR PRESSURE MONITOR : CONSULT Function (BCM-AIR PRESSURE MONITOR)" (with Intelligent Key System) or BCS-94, "AIR PRESSURE MONITOR : CONSULT Function (BCM-AIR PRESSURE MONITOR)" (without Intelligent Key System).

>> Inspection End.

Basic inspection

...

ID registration procedure

Description This procedure must be performed after replacement of a tire pressure sensor or BCM. Work Procedure TPMS ID registration can be performed using one of the following procedures: &n ...

Other materials:

Door outside molding
Exploded View Front door panel Front door outside molding Rear door panel Rear door outside molding Pawl Removal and Installation FRONT DOOR OUTSIDE MOLDING Removal Lower front door glass. Remove door mirror. Refer to MIR-22, "Removal and Installa ...

Preparation
Special Service Tool The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description — (J-39570) Chassis Ear Locating the noise — (J-50397) NISSAN Squeak and Rattle Kit ...

Bluetooth® streaming audio without Navigation System (if so equipped)
If you have a compatible Bluetooth® audio device that is capable of playing audio files, the device can be connected to the vehicle’s audio system so that the audio files on the device play through the vehicle’s speakers. Connecting Bluetooth® audio To connect your Bluetooth® audio ...