Nissan Rogue Service Manual: Consult/gst checking system

Nissan Rogue Service Manual / General information / Basic inspection / Consult/gst checking system

Description

NOTE: This vehicle is diagnosed using the CONSULT-III plus.

When CONSULT is connected with a data link connector equipped on the vehicle side, it will communicate with the control unit equipped in the vehicle and then enable various kinds of diagnostic tests.

Description

Hood release handle
Data link connector

Refer to “CONSULT-III plus Operation Manual” for more information.

Function and System Application

Function and System Application

x: Applicable
1: If equipped

CONSULT Data Link Connector (DLC) Circuit

INSPECTION PROCEDURE

If the CONSULT cannot diagnose the system properly, check the following items.

Symptom	Check item
CONSULT cannot access any system.	CONSULT DLC power supply circuit (Terminal 8 and 16) and ground circuit (Terminal 4 and 5)
CONSULT cannot access individual system. (Other systems can be accessed.)	Power supply and ground circuit for the control unit of the system (For detailed circuit, refer to wiring diagram for each system.) Open or short circuit between the system and CONSULT DLC (For detailed circuit, refer to wiring diagram for each system.) Open or short circuit CAN communication line. Refer to LAN-17, "Trouble Diagnosis Flow Chart"

NOTE: The DDL2 circuits and CAN communication lines from DLC pins 6, 7 and 14 may be connected to more than one system. A short in a DDL circuit or CAN lines connected to a control unit in one system may affect CONSULT access to other systems. For a complete DDL circuit layout, refer to GI-51, "Wiring Diagram - CONSULT/ GST CHECKING SYSTEM". For a complete CAN line layout, refer to LAN-35, "Wiring Diagram - CAN SYSTEM -".

Wiring Diagram - CONSULT/GST CHECKING SYSTEM

Wiring Diagram

Circuit inspection

DESCRIPTION In general, testing electrical circuits is an easy task if it is approached in a logical and organized method. Before beginning it is important to have all available informa ...

Engine

...

Other materials:

Personal lamp
Removal and Installation The personal lamp is serviced as part of headlining. Refer to INT-30, "Removal and Installation". Bulb or Lens Replacement WARNING: Do not touch the glass surface of a bulb while it is lit or right after being turned OFF to prevent burns. CAUTION: &n ...

Removal and installation
HOOD Exploded View Hood hinge (RH) Hood Hood side seal Hood front seal Hood center seal Bumper rubber Hood insulator Hood rod clamp Hood support rod Hood rod grommet Hood hinge (LH) HOOD ASSEMBLY HOOD ASSEMBLY : Remova ...

Unit disassembly and assembly
FRONT COMBINATION LAMP Exploded View Front combination lamp Parking (side marker) lamp bulb socket Headlamp (low beam) bulb Plastic cover Headlamp (high beam) bulb Turn signal lamp bulb socket Disassembly and Assembly DISASSEMBLY Remove front combinat ...