Nissan Rogue Service Manual: Component parts

Nissan Rogue Service Manual / Cruise control / Drive Mode System / System description / Component parts

Component Parts Location

Instrument lower panel LH

No.	Component	Function
1	Combination meter	The combination meter transmittes the following signal via CAN communications to the TCM. SPORT mode switch signal The combination meter receives the following signal via CAN communications from the ECM. SPORT mode indicator signal Refer to MWI-6, "METER SYSTEM : Component Parts Location" for detailed installation location.
2	TCM	The TCM receives the following signal via CAN communications from the combination meter. SPORT mode switch signal The TCM transmittes the following signal via CAN communications to the ECM. SPORT mode signal Refer to TM-12, "CVT CONTROL SYSTEM : Component Parts Location" for detailed installation location.
3	ECM	The ECM receives the following signal via CAN communications from the TCM. SPORT mode signal The ECM transmittes the following signal via CAN communications to the combination meter. SPORT mode indicator signal Refer to EC-14, "Component Parts Location" for detailed installation location.
4	SPORT mode switch	Refer to DMS-4, "SPORT Mode Switch".

SPORT Mode Switch

The SPORT mode switch is installed to the instrument lower finisher.
When the SPORT mode indicator lamp on the combination meter is OFF and the SPORT mode switch is pressed, the SPORT mode is active and the SPORT mode indicator lamp is ON.
When the SPORT mode indicator lamp on the combination meter is ON and the SPORT mode switch is pressed, the SPORT mode is cancelled and the SPORT mode indicator lamp is OFF.

SPORT Mode Switch

SPORT Mode Indicator Lamp

DESIGN/PURPOSE

The SPORT mode indicator lamp inform the driver that the vehicle is in SPORT mode.

SPORT Mode Indicator Lamp

BULB CHECK

Not applicable

SYSTEM DIAGRAM

System diagram

SIGNAL PATH

TCM receives SPORT mode switch signal (ON/OFF) from combination meter via CAN communication.

Based on the signal, TCM transmits SPORT mode signal to ECM via CAN communication.
ECM transmits SPORT mode indicator signal to combination meter via CAN communication. Based on the signal, combination meter illuminates SPORT mode indicator lamp.

LIGHTING CONDITION

When all of the following conditions are satisfied

Ignition switch: ON
The SPORT mode switch is pressed when the SPORT mode indicator lamp is OFF

SHUTOFF CONDITION

When any of the condition listed below is satisfied.

Ignition switch: Other than ON
The SPORT mode switch is pressed when the SPORT mode indicator lamp is ON.

System

SPORT MODE CONTROL SPORT MODE CONTROL : System Description SYSTEM DIAGRAM SYSTEM DISCRIPTION TCM receives SPORT mode switch signal (ON/OFF) from combination meter via CAN communica ...

Other materials:

Front wiper drive assembly
Exploded View REMOVAL Cowl top Front wiper drive assembly Removal and Installation REMOVAL Remove cowl top cover. Refer to EXT-25, "Removal and Installation". Disconnect harness connector from front wiper motor. Remove bolts and front wiper driv ...

Malfunction indicator lamp
Component Function Check 1.CHECK MIL FUNCTION Turn ignition switch ON. Check that MIL illuminates. Is the inspection result normal? YES >> INSPECTION END NO >> Proceed to EC-476, "Diagnosis Procedure". Diagnosis Procedure 1.CHECK DTC Check that DTC UX ...

P0456 EVAP control system
DTC Description DTC DETECTION LOGIC This diagnosis detects leaks in the EVAP line between fuel tank and EVAP canister purge volume control solenoid valve, using the negative pressure caused by decrease of fuel temperature in the fuel tank after turning ignition switch OFF. If ECM judges t ...