Nissan Rogue Owners Manual: Changing engine oil filter
>
Changing engine oil filter
- Park the vehicle on a level surface and apply
the parking brake.
- Turn the engine off.
- Place a large drain pan under the oil filter B .
- Remove pins C from the right engine protector
located inside right wheel well, remove
protector. Remove oil filter B with an
oil filter wrench by turning it counterclockwise.
Then remove the oil filter by turning it
by hand.
CAUTION Be careful not to burn yourself. The engine
oil may be hot. |
- Wipe the engine oil filter sealing surface with
a clean rag.
CAUTION
- Be sure to remove any old gasket
material remaining on the sealing
surface of the engine. Failure to do
so could lead to an oil leak and engine
damage.
- The dipstick must be inserted in
place to prevent oil spillage from the
dipstick hole when filling the engine
with oil.
|
- Coat the gasket on the new filter with clean
engine oil.
- Screw on the oil filter until a slight resistance
is felt, then tighten an additional 2/3 turn.
- Start the engine and check for leakage
around the oil filter. Correct as required.
- Turn the engine off and wait more than
10 minutes. Check the oil level. Add engine
oil if necessary.
Changing engine oil
Park the vehicle on a level surface and apply
the parking brake.
Start the engine and let it idle until it reaches
operating temperature, then turn it off.
& ...
CAUTION
NISSAN recommends using Genuine
NISSAN CVT Fluid NS-3 ONLY in
NISSAN CVTs. Do not mix with other
fluids.
Do not use Automatic transmission
fluid (ATF ...
Other materials:
Active engine brake
The Active Engine Brake function adds subtle
deceleration by controlling CVT gear ratio, depending
on the cornering condition calculated
from driver’s steering input and plural sensors.
This benefit is for easier traceability and less
workload of adjusting speed with braking at corners.
...
Steering gear and linkage
Inspection
BOOT
Check boot for cracks. Replace if any damage is found.
OUTER SOCKET AND INNER SOCKET
Boot
Check boot for cracks, and replace it if a malfunction is
detected.
Gear Housing
Check gear housing for damage and scratches (inner wall). Replace
if there are a ...
Component parts
Component Parts Location
Combination meter
Engine room (LH)
Left front wheel assembly
Behind instrument panel (LH)
Left rear wheel assembly
Left rear wheel assembly
Wheel
No.
Component parts
Function
1
Combination meter
The combinati ...
© 2014-2024 Copyright www.nirogue.com