Nissan Rogue Owners Manual: Changing engine oil

Nissan Rogue Owners Manual / Maintenance and do-it-yourself / Engine oil / Changing engine oil

Changing engine oil

Park the vehicle on a level surface and apply the parking brake.
Start the engine and let it idle until it reaches operating temperature, then turn it off.
Remove the oil filler cap B by turning it counterclockwise.
Place a large drain pan under the drain plug A .
Remove the drain plug A with a wrench by turning it counterclockwise and completely drain the oil.

If the oil filter is to be changed, remove and replace it at this time. See “Changing engine oil filter” in this section.

Waste oil must be disposed of properly.
Check your local regulations.

WARNING

Prolonged and repeated contact with used engine oil may cause skin cancer.
Try to avoid direct skin contact with used oil. If skin contact is made, wash thoroughly with soap or hand cleaner as soon as possible.
Keep used engine oil out of reach of children.

CAUTION

Be careful not to burn yourself. The engine oil may be hot.

Clean and reinstall the drain plug and a new washer. Securely tighten the drain plug with a wrench. Do not use excessive force.
Drain plug tightening torque: 22 - 29 ft-lb (29 - 39 N·m)
Refill engine with recommended oil through the oil filler opening, then install the oil filler cap securely.
For additional information, refer to “Recommended fluids/lubricants and capacities” in the “Technical and consumer information” section of this manual for drain and refill capacity.

The drain and refill capacity depends on the oil temperature and drain time. Use these specifications for reference only. Always use the dipstick to determine when the proper amount of oil is in the engine.
Start the engine. Check for leakage around the drain plug and oil filter. Correct as required.
Turn the engine off and wait more than 10 minutes. Check the oil level with the dipstick. Add engine oil if necessary.

Checking engine oil level

Checking engine oil level Park the vehicle on a level surface and apply the parking brake. Start the engine and let it idle until it reaches operating temperature. Turn off ...

Changing engine oil filter

> Changing engine oil filter Park the vehicle on a level surface and apply the parking brake. Turn the engine off. Place a large drain pan under the oil filter B . Remove pins ...

Other materials:

U1001 CAN comm circuit
Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each co ...

Steering wheel switch for audio control
SOURCE select switch With the ignition switch in the ACC or ON position, push the SOURCE switch to turn the audio system on. Push the source select switch to change the mode in the following sequence: AM→FM1→FM2→SXM1 (satellite radio, if so equipped) → SXM2 (satellite radio, if so e ...

The braking distance is long
Description Brake stopping distance is long when ABS function is operated. Diagnosis Procedure CAUTION: Brake stopping distance on slippery road like rough road, gravel road or snowy road may become longer when ABS is operated than when ABS is not operated 1.CHECK BRAKING FORCE Check brake ...