Nissan Rogue Owners Manual: CD care and cleaning

Nissan Rogue Owners Manual / Monitor, climate, audio, phone and voice recognition systems / Audio system / CD care and cleaning

CD care and cleaning

Handle a CD by its edges. Do not bend the disc. Never touch the surface of the disc.
Always place the discs in the storage case when they are not being used.
To clean a disc, wipe the surface from the center to the outer edge using a clean, soft cloth. Do not wipe the disc using a circular motion.
Do not use a conventional record cleaner or alcohol intended for industrial use.
A new disc may be rough on the inner and outer edges. Remove the rough edges by rubbing the inner and outer edges with the side of a pen or pencil as illustrated.

CD care and cleaning

Source select and power on switch
Menu control switch/ENTER button
(Back) switch
Volume control switc

Bluetooth® streaming audio with Navigation System

If you have a compatible Bluetooth® audio device that is capable of playing audio files, the device can be connected to the vehicle’s audio system so that the audio files on the device play thr ...

Steering wheel switch for audio control

SOURCE select switch With the ignition switch in the ACC or ON position, push the SOURCE switch to turn the audio system on. Push the source select switch to change the mode in the following se ...

Other materials:

DTC/circuit diagnosis
POWER SUPPLY AND GROUND CIRCUIT BCM (BODY CONTROL SYSTEM) (WITH INTELLIGENT KEY SYSTEM) BCM (BODY CONTROL SYSTEM) (WITH INTELLIGENT KEY SYSTEM) : Diagnosis Procedure Regarding Wiring Diagram information, refer to BCS-50, "Wiring Diagram". 1. CHECK FUSE Check that the following fuse i ...

Heater operation
Heating This mode is used to direct heated air to the foot outlets. Some air also flows from the defrost outlets and the side vent outlets. Press the button to change to fresh air intake mode. The indicator light will turn off for normal heating. Press the air flow ...

Preparation
Special Service Tool The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description KV38100500 ( — ) Drift Installing sensor rotor a: 80 mm (3.15 in) dia. b: 60 mm (2.36 in) dia. KV40 ...