Nissan Rogue Service Manual: Calibration of decel G sensor

Nissan Rogue Service Manual / Brakes / Brake Control System / Basic inspection / Calibration of decel G sensor

Description

CAUTION: Always perform the decel G sensor calibration before driving when the following operation is performed.

NOTE: Yaw rate/side/decel G sensor calibration is performed when performing the decel G sensor calibration.

Description

Work Procedure

Decel G sensor calibration

CAUTION: Always use CONSULT for the decel G sensor calibration. (It cannot be adjusted other than with CONSULT.) NOTE: Yaw rate/side/decel G sensor calibration is performed when performing the decel G sensor calibration.

1.CHECK THE VEHICLE STATUS

Steer the steering wheel to the straight-ahead position. Stop the vehicle on level surface.
Stop the engine.
Turn the ignition switch OFF.

Is the vehicle stopped in the straight-ahead position on level surface? YES >> GO TO 2.

NO >> Steer the steering wheel to the straight-ahead position. Stop the vehicle on level surface.

2.PERFORM DECEL G SENSOR CALIBRATION

CAUTION:

Never allow passenger or load on the vehicle.
Never apply vibration to the vehicle body when opening or closing door during calibration.

With CONSULT

Turn the ignition switch ON.
CAUTION: Never start engine.
Select “ABS”, “WORK SUPPORT”, “DECEL G SEN CALIBRATION” in this order.
Select “START”.
After approx. 10 seconds, select “END”.
Turn ignition switch OFF and then turn it ON again.

CAUTION: Be sure to perform the operation above. >> GO TO 3.

3.CHECK DATA MONITOR

With CONSULT

Drive the vehicle. Steer the steering wheel to the straight-ahead position. Stop the vehicle on level surface.
Select “ABS”, “DATA MONITOR”, “ECU INPUT SIGNALS” and “DECEL G SENSOR” in this order. Check that the signal is within the specified value.

DECEL G SENSOR : Approx. ± 0.01 G

Is the inspection result normal? YES >> GO TO 4.

NO >> GO TO 1.

4.ERASE SELF-DIAGNOSIS MEMORY

With CONSULT

Erase self-diagnosis result of “ABS”.

Are the memories erased? YES >> Inspection End.

NO >> Check the items indicated by the self-diagnosis.

Adjustment of steering angle sensor neutral position

Description Refer to the table below to determine if adjustment of steering angle sensor neutral position is required. Work Procedure ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION CAU ...

DTC/circuit diagnosis

...

Other materials:

Safety belts
General information The vehicle is fitted with five or seven safety belts to ensure occupant safety. However, they can only unfold their protective effect when adjusted correctly. Always make sure that safety belts are being worn by the occupants before driving off. The airbags supplement the safety ...

Diagnosis system (BCM)
WITH INTELLIGENT KEY WITH INTELLIGENT KEY : CONSULT Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT performs the following functions via CAN communication with BCM. Direct Diagnostic Mode Description Ecu Identification The BCM part number is displayed. Self D ...

Back door window glass
Exploded View Back door window glass Clip Clip Removal and Installation REMOVAL Remove back door finisher. Refer to INT-38, "Removal and Installation". Remove back door lock. Refer to DLK-263, "DOOR LOCK : Removal and Installation" (for i ...