Nissan Rogue manuals

Nissan Rogue Service Manual: C1770, C1771, C1772, C1773 G sensor

DTC Description

DTC DETECTION LOGIC

DTC Display Item Malfunction Detected Condition Possible Causes
C1770 G SENSOR FL (G sensor front left) Malfunction in the G sensor data from front left wheel sensor.
  • Tire pressure sensor
  •  Tire pressure receiver
C1771 G SENSOR FR (G sensor front right) Malfunction in the G sensor data from front right wheel sensor.
C1772 G SENSOR RL (G sensor rear left) Malfunction in the G sensor data from rear left wheel sensor.
C1773 G SENSOR RR (G sensor rear right) Malfunction in the G sensor data from rear right wheel sensor.

Diagnosis Procedure

1.REPLACE WHEEL SENSOR

When DTC "C1770, C1771, C1772, C1773" is detected, replace wheel sensor.

>> Replace wheel sensor. Refer to BRC-132, "FRONT WHEEL SENSOR : Removal and Installation" (front wheel sensor), BRC-134, "REAR WHEEL SENSOR : Removal and Installation" (rear wheel sensor).

C1769 configuration setting
DTC Description This procedure must be performed:  After replacement of BCM. DTC DETECTION LOGIC DTC Display Item Malfunction detected condition C1769 CONFIG SET ...

U1000 CAN COMM CIRCUIT
Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellen ...

Other materials:

Forward-facing child restraint installation using LATCH
For additional information, refer to all Warnings and Cautions in the “Child Safety” and “Child Restraints” sections before installing a child restraint. NISSAN does not recommend the use of the lower anchors if the combined weight of the child and the child restraint exceeds 65 lbs ( ...

Repairing material
Foam Repair During factory body assembly, foam insulators are installed in certain body panels and locations around the vehicle. Use the following procedure(s) to replace any factory-installed foam insulators. URETHANE FOAM APPLICATIONS Use commercially available Urethane foam for sealant (f ...

Basic inspection
DIAGNOSIS AND REPAIR WORK FLOW Work Flow OVERALL SEQUENCE DETAILED FLOW 1.OBTAIN INFORMATION ABOUT SYMPTOM Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred. >> GO TO 2. 2.CHECK SYMPTOM ...

© 2014-2025 Copyright www.nirogue.com