DTC Description
This procedure must be performed:
DTC DETECTION LOGIC
DTC | Display Item | Malfunction detected condition |
C1769 | CONFIG SETTING (Configuration setting) | Tire air pressure monitoring system configuration cannot be performed. |
Receiver ID registration cannot be performed. |
Diagnosis Procedure
1.TIRE PRESSURE MONITORING SYSTEM CONFIGURATION
Perform configuration.
>> Refer to WT-21, "Work Procedure", and GO TO 2.
2.TIRE PRESSURE SENSOR ID REGISTRATION
Perform tire pressure sensor ID registration. Refer to WT-21, "Work Procedure".
Does low tire pressure warning lamp turn OFF? YES >> Inspection End.
NO >> Configuration setting tire pressure monitoring system. Refer to WT-21, "Work Procedure".
Accelerator pedal released position learning
Description
Accelerator Pedal Released Position Learning is a function of ECM to learn
the fully released position of the
accelerator pedal by monitoring the accelerator pedal position sensor output
signal. It must be performed each
time harness connector of accelerator pedal position sensor ...
Diagnosis system (TCM)
DIAGNOSIS DESCRIPTION
DIAGNOSIS DESCRIPTION : 1 Trip Detection Diagnosis and 2 Trip Detection
Diagnosis
NOTE:
“Start the engine and turn OFF the ignition switch after warm-up.” This is
defined as 1 trip.
1 TRIP DETECTION DIAGNOSIS
When initial malfunction is detected, TCM memorizes DTC. ...
Unit disassembly and assembly
STEERING GEAR AND LINKAGE
Exploded View
DISASSEMBLY AND ASSEMBLY
Steering gear
Inner boot clamp
Boot
Outer boot clamp
Outer socket
Disassembly and Assembly
DISASSEMBLY
Remove outer socket lock nut and remove outer socket.
Remove inne ...