Nissan Rogue manuals

Nissan Rogue Service Manual: C1729 vehicle speed signal

DTC Logic

NOTE: The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.

DTC DETECTION LOGIC

DTC Display Item Malfunction Detected Condition Possible Cause
C1729 VHCL SPEED SIG ERR Vehicle speed signal not detected
  • CAN communication
  •  BCM
  •  Combination meter

DTC CONFIRMATION PROCEDURE

1.PERFORM SELF DIAGNOSTIC RESULT

With CONSULT.

  1.  Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for 10 minutes.
  2.  Perform Self Diagnostic Result.

Is DTC C1729 detected? YES >> Proceed to WT-31, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

NOTE: The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.

1.PERFORM SELF DIAGNOSTIC RESULT FOR COMBINATION METER

With CONSULT

Perform Self Diagnostic Result for METER M&A. Refer to MWI-21, "CONSULT Function (METER/M&A)".

Are any DTCs detected? YES >> Refer to BCS-48, "DTC Index" (with Intelligent Key System) or BCS-108, "DTC Index" (without Intelligent Key System).

NO >> Replace the BCM. Refer to BCS-75, "Removal and Installation" (with Intelligent Key System) or BCS-135, "Removal and Installation" (without Intelligent Key System).

C1716, C1717, C1718, C1719 transmitter (pressure data)
DTC Logic NOTE: The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.  Activate and dis ...

C1730, C1731, C1732, C1733 flat tire
DTC Logic NOTE: The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.  Activate and dis ...

Other materials:

CAN system (type 3)
MAIN LINE BETWEEN IPDM-E AND DLC CIRCUIT Diagnosis Procedure 1.CHECK CONNECTOR  Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal.  Check the following terminals and connectors for damage, bend and loose connection (connector side and harn ...

Rear window wiper and washer switch
WARNINGIn freezing temperatures the washer solution may freeze on the window and obscure your vision. Warm the rear window with the defroster before you wash the rear window.   CAUTION  Do not operate the washer continuously for more than 30 seconds ...

B1429 seat belt buckle switch RH
Description DTC B1429 SEAT BELT BUCKLE SWITCH RH The air bag diagnosis sensor unit monitors the seat belt buckle switch RH status. If the control unit detects an open or short condition in the circuit, it will set the DTC. PART LOCATION Refer to SRC-6, "Component Parts Location". D ...

В© 2014-2024 Copyright www.nirogue.com