DTC Logic
NOTE: The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.
DTC DETECTION LOGIC
DTC |
Display Item |
Malfunction Detected Condition |
Possible Cause |
C1704 | LOW PRESSURE FL | Front LH tire pressure drops to 187.5 kPa (26.5 psi) or less. |
|
C1705 | LOW PRESSURE FR | Front RH tire pressure drops to 187.5 kPa (26.5 psi) or less. | |
C1706 | LOW PRESSURE RR | Rear RH tire pressure drops to 187.5 kPa (26.5 psi) or less. | |
C1707 | LOW PRESSURE RL | Rear LH tire pressure drops to 187.5 kPa (26.5 psi) or less. |
DTC CONFIRMATION PROCEDURE
1.PERFORM SELF DIAGNOSTIC RESULT
With CONSULT
Is DTC C1704, C1705, C1706, or C1707 detected? YES >> Proceed to WT-24, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
NOTE: The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.
1.TIRE PRESSURE SENSOR ID REGISTRATION
Perform tire pressure sensor ID registration. Refer to WT-21, "Work Procedure".
Can the tire pressure sensor ID registration be completed? YES >> GO TO 2.
NO >> Replace applicable tire pressure sensor. Refer to WT-61, "Removal and Installation".
2.CHECK TIRE PRESSURE
Check the air pressure of all wheels. Refer to WT-65, "Tire Air Pressure".
Is the inspection result normal?
YES >> Perform DTC CONFIRMATION PROCEDURE again. Refer to WT-24, "DTC Logic".
NO >> GO TO 3.
3.CHECK TIRE PRESSURE SIGNAL
With CONSULT
Monitor item |
Displayed value |
AIR PRESS FL | Approximately equal to value indicated on tire gauge for front LH tire |
AIR PRESS FR | Approximately equal to value indicated on tire gauge for front RH tire |
AIR PRESS RR | Approximately equal to value indicated on tire gauge for rear RH tire |
AIR PRESS RL | Approximately equal to value indicated on tire gauge for rear LH tire |
Is the inspection result normal? YES >> Inspection End.
NO >> Repair or replace malfunctioning components.
ECU diagnosis information
FRONT AIR CONTROL
Reference Value
TERMINAL LAYOUT
PHYSICAL VALUES
DTC Inspection Priority Chart
If some DTCs are displayed at the same time, perform inspections one by one
based on the following priority
chart.
Priority
Detected items (DTC)
1
...
Periodic maintenance
Introduction of Periodic Maintenance
The following tables show the normal maintenance schedule. Depending upon
weather and atmospheric conditions,
varying road surfaces, individual driving habits and vehicle usage, additional
or more frequent maintenance
may be required.
Periodic maintenan ...
Luggage trim
Exploded View
WITH THIRD ROW SEAT
Tonneau cover (if equipped)
Strap (LH/RH)
Luggage floor finisher (RH)
Luggage floor center finisher
Luggage floor finisher (LH)
Luggage side lower finisher (LH)
Luggage side upper finisher (LH)
Hooks (LH/RH)
Lug ...