Nissan Rogue manuals

Nissan Rogue Service Manual: C1607, C1608 EPS control unit

DTC Logic

DTC DETECTION LOGIC

DTC

Display item

Malfunction detected condition

Possible cause

C1607 EEPROM When the memory (EEPROM) system malfunction is detected in EPS control unit. EPS control unit
C1608 CONTROL UNIT When the internal malfunction is detected in EPS control unit.

DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

>> GO TO 2.

2.DTC REPRODUCTION PROCEDURE

With CONSULT

  1.  Turn the ignition switch OFF to ON.
  2.  Perform “EPS” self-diagnosis.

Is DTC “C1607” or “C1608” detected? YES >> Proceed to diagnosis procedure. Refer to STC-25, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.CHECK TERMINALS AND HARNESS CONNECTORS

Check EPS control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace malfunctioning parts.

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace malfunctioning parts.

2.PERFORM SELF-DIAGNOSIS

With CONSULT

  1.  Erase self-diagnostic results for “EPS”.
  2.  Turn the ignition switch OFF, and then wait 10 seconds and more.
  3.  Perform self-diagnosis for “EPS”.

Is DTC “C1607” or “C1608” detected? YES >> EPS control unit is malfunctioning. Replace steering column assembly. Refer to STC-36, "Removal and Installation".

NO >> Check intermittent incident. Refer to GI-41, "Intermittent Incident".

C1606 EPS motor
DTC Logic DTC DETECTION LOGIC DTC Display item Malfunction detected condition Possible cause C1606 EPS MOTOR When the motor driver malfunction of EPS c ...

C1609 vehicle speed signal
DTC Logic DTC DETECTION LOGIC DTC Display item Malfunction detected condition Possible cause C1609 CAN VHCL SPEED Malfunction is detected in v ...

Other materials:

PostCrash - iBrake
Principle In the event of an accident, PostCrash can bring the vehicle to a halt automatically without intervention by the driver in certain situations. General information PostCrash can reduce the risk of another collision and subsequent consequences. At standstill After coming to a halt, the brake ...

P0137 HO2S2
DTC Description DTC DETECTION LOGIC The heated oxygen sensor 2 has a much longer switching time between rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen storage capacity of the three way catalyst (manifold) causes the longer switching time. To judge the malfunctions of heated ox ...

Active Protection
Principle Active Protection prepares occupants and the vehicle for a possible accident in critical driving or collision situations. General information Depending on the equipment and national-market version, Active Protection consists of various PreCrash functions. The system is used to detect cert ...

© 2014-2022 Copyright www.nirogue.com