Nissan Rogue Service Manual: C1606 EPS motor
DTC Logic
DTC DETECTION LOGIC
|
DTC |
Display item |
Malfunction detected condition |
Possible cause |
| C1606 | EPS MOTOR | When the motor driver malfunction of EPS control unit or EPS motor malfunction is detected. |
|
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.DTC REPRODUCTION PROCEDURE
With CONSULT
- Turn the ignition switch OFF to ON.
- Perform “EPS” self-diagnosis.
Is DTC “C1606” detected? YES >> Proceed to diagnosis procedure. Refer to STC-24, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.PERFORM SELF-DIAGNOSIS
With CONSULT
- Erase self-diagnostic results for “EPS”.
- Turn the ignition switch OFF, and then wait 10 seconds and more.
- Perform self-diagnosis for “EPS”.
Is DTC “C1606” detected? YES >> EPS motor is malfunctioning. Replace steering column assembly. Refer to ST-12, "Removal and Installation".
NO >> Check EPS control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace malfunctioning parts.
C1604 torque sensor
DTC Logic
DTC DETECTION LOGIC
DTC
Display item
Malfunction detected condition
Possible cause
C1604
TORQUE SENSOR
When torque sensor output signal is ma ...
C1607, C1608 EPS control unit
DTC Logic
DTC DETECTION LOGIC
DTC
Display item
Malfunction detected condition
Possible cause
C1607
EEPROM
When the memory (EEPROM) system malfunction i ...
Other materials:
Body side trim
Exploded View
Front pillar finisher
Front body side welt
Center pillar upper finisher
Rear body side welt
Rear kicking plate
Seat belt cover
Center pillar lower finisher
Front kicking plate
Dash side finisher
Pawl
Clip
Front
FRONT PILLAR FINISHER
...
Replacement operations
Description
This section is prepared for technicians who have attained a high level
of skill and experience in repairing
collision-damaged vehicles and also use modern service tools and equipment.
Persons unfamiliar with body
repair techniques should not attempt to repair collision-dam ...
P0075 intake valve timing control
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P0075
INT/V TIM V/CIR-B1
(Intake valve control solenoid circuit bank 1)
ECM detects an abnormal voltage in the intake valve timing
co ...
