DTC Logic
DTC DETECTION LOGIC
DTC | Display Item | Malfunction detected condition | Possible causes |
C1160 | DECEL G SEN SET | When calibration of yaw rate/side/decel G sensor is not complete. |
|
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAGNOSTIC RESULT
With CONSULT.
Is DTC C1160 detected? YES >> Proceed to diagnosis procedure. Refer to BRC-101, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.DECEL G SENSOR CALIBRATION
Perform decel G sensor calibration. Refer to BRC-72, "Work Procedure".
>> GO TO 2.
2.CHECK SELF-DIAGNOSTIC RESULT
With CONSULT.
Perform self-diagnostic result.
Is DTC C1160 detected? YES >> GO TO 3.
NO >> Inspection End.
3.CHECK YAW RATE/SIDE/DECEL G SENSOR SYSTEM
Check yaw rate/side/decel G sensor system. Refer to BRC-84, "Diagnosis Procedure".
Is the inspection result normal? YES >> Replace ABS actuator and electric unit (control unit). Refer to BRC-136, "Removal and Installation".
NO >> Repair or replace malfunctioning components.
P052A, P052B intake valve timing control
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P052A
CAMSHAFT POSITION TIMING B1
(Cold start “A” camshaft position timing
over-advanced bank 1)
There is a gap between angle of target and ...
Starting the engine (models without NISSAN
Intelligent Key® system)
Apply the parking brake.
Move the shift lever to P (Park) or N (Neutral).
P (Park) is recommended.
The shift lever cannot be moved out of
P (Park) and into any of the other gear
positions if the ignition key is turned to
the OFF position or if the key is removed
from the ignition ...
Towing recommended by NISSAN
All-Wheel Drive (AWD) models
NISSAN recommends that towing dollies be
used when towing your vehicle or the vehicle be
placed on a flatbed truck as illustrated.
CAUTIONDO NOT tow AWD models with any of the
wheels on the ground as this may cause
serious and expensive damage to the ...