Nissan Rogue Service Manual: C1130 engine signal
DTC Logic
DTC DETECTION LOGIC
| DTC | Display Item | Malfunction detected condition | Possible causes |
| C1130 | ENGINE SIGNAL 1 | When a malfunction is detected in ECM system. |
|
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAGNOSTIC RESULT
With CONSULT.
- Turn ignition switch OFF to ON.
- Perform self-diagnostic result.
Is DTC C1130 detected? YES >> Proceed to diagnosis procedure. Refer to BRC-91, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.CHECK SELF-DIAGNOSTIC RESULT FOR ENGINE SYSTEM
With CONSULT.
Perform self-diagnostic result. Refer to EC-67, "CONSULT Function".
Are any ECM DTCs detected? YES >> Refer to EC-93, "DTC Index".
NO >> GO TO 2.
2.CHECK SELF-DIAGNOSTIC RESULT FOR ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
With CONSULT.
- Perform self-diagnostic result and erase DTCs.
- Turn ignition switch OFF.
- Start engine and drive vehicle for a short period of time.
- Check that malfunction indicator lamp (MIL) turns OFF.
- Stop vehicle and perform self-diagnostic result.
Is DTC C1130 detected? YES >> Replace ABS actuator and electric unit (control unit). Refer to BRC-136, "Removal and Installation".
NO >> Check pin terminals and connection of connectors for abnormal conditions. Repair or replace malfunctioning components.
C1121, C1123, C1125, C1127 ABS out valve system
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
C1121
FR LH OUT ABS SOL
When a malfunction is detected in front LH ABS OU ...
C1140 actuator relay system
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
C1140
ACTUATOR RLY
When a malfunction is detected in actuator relay.
...
Other materials:
Unbalance steering wheel turning force and return between
right and left
Description
Unbalance steering wheel turning force and return between right and left.
Diagnosis Procedure
1.CHECK THE ILLUMINATION OF THE EPS WARNING LAMP
Check the EPS warning lamp while engine is running.
Does the EPS warning lamp turn OFF?
YES >> GO TO 2.
NO >> Refer to STC ...
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
...
Room lamp
Removal and Installation
WARNING:
Do not touch the glass surface of a bulb while it is lit or right after being
turned OFF to prevent burns.
CAUTION:
Do not touch the glass of bulb directly by hand. Keep grease
and other oily substances away from
bulb surface.
Do not le ...
