Nissan Rogue manuals

Nissan Rogue Service Manual: C1111 pump motor

DTC Logic

DTC DETECTION LOGIC

DTC Display Item Malfunction detected condition Possible causes
C1111 PUMP MOTOR When a malfunction is detected in motor or motor relay.
  • Harness or connector
  •  ABS actuator and electric unit (control unit)
  •  Fusible link
  •  Battery power supply system

DTC CONFIRMATION PROCEDURE

1.CHECK SELF-DIAGNOSTIC RESULT

With CONSULT.

  1.  Turn ignition switch OFF.
  2.  Depress brake pedal 20 times or more.
  3.  Start the engine and wait for 3 minutes or more.
  4.  Perform self-diagnostic result.

Is DTC C1111 detected? YES >> Proceed to diagnosis procedure. Refer to BRC-82, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

Regarding Wiring Diagram information, refer to BRC-57, "Wiring Diagram".

1.CONNECTOR INSPECTION

  1.  Turn ignition switch OFF.
  2.  Disconnect ABS actuator and electric unit (control unit) connectors.
  3.  Check connectors and terminals for deformation, disconnection, looseness or damage.

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace as necessary.

2.CHECK ABS MOTOR AND MOTOR RELAY BATTERY POWER SUPPLY

Check voltage between ABS actuator and electric unit (control unit) connector E125 terminal 1 and ground.

Check ABS motor and motor relay battery power supply

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace malfunctioning components.

3.CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) GROUND CIRCUIT

Check continuity between ABS actuator and electric unit (control unit) connector E125 terminals 13, 38 and ground.

Check ABS actuator and electric unit (control unit) ground circuit

Is the inspection result normal? YES >> Replace ABS actuator and electric unit (control unit). Refer to BRC-136, "Removal and Installation" NO >> Repair or replace harness.

C1109 power and ground system
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1109 BATTERY VOLTAGE [ABNORMAL] When ignition voltage is 10 ...

C1113, C1145, C1146 yaw rate/side/decel G sensor
DTC Display Item Malfunction detected condition Possible causes C1113 G SENSOR When a malfunction is detected in longitudinal G sensor signal. Harness or ...

Other materials:

Side air bag (satellite) sensor
Exploded View Front door satellite sensor Front side air bag satellite sensor Rear side satellite sensor Satellite sensor harness connector  Bolt  Nut  Pawl Front NOTE: RH side shown, LH side similar. Removal and Installation WARNING:  Bef ...

B14XX air bag diagnosis sensor unit
Description DTC B1XXX AIR BAG DIAGNOSIS SENSOR UNIT The air bag diagnosis sensor unit will run self diagnostics when the ignition switch is turned ON. It has the potential to set many diagnostic trouble codes which will conform to the B1XXX format, but will not match any other SRS diagnostic ...

Sunshade
Removal and Installation REMOVAL Remove the moonroof unit assembly. Refer to RF-53, "Removal and Installation". Place the moonroof unit assembly (1) on a flat surface upside down and remove sunshade (2) screws (A). Manually move sunshade motor (1) using suitable tool (2 ...

В© 2014-2024 Copyright www.nirogue.com