Nissan Rogue Service Manual: Brake pedal
Exploded View
- Rivet
- Clevis pin
- Brake pedal
- Brake pedal pad
- Clip
- Snap pin
- Stop lamp switch
- Brake pedal position switch
Removal and Installation
REMOVAL
- Remove instrument lower panel LH. Refer to IP-22, "Removal and Installation".
- Remove the knee protector. Refer to IP-14, "Exploded View".
- Remove snap pin and clevis pin from clevis of brake booster.
- Disconnect the harness connectors from the stop lamp switch and brake pedal position switch.
- Remove the accelerator pedal. Refer to ACC-3, "Removal and Installation".
- Remove the brake pedal.
CAUTION: Support the brake booster and master cylinder to prevent contact with other components.
INSPECTION AFTER REMOVAL
- Check the following items and replace the brake pedal assembly if necessary.
- Check the brake pedal rivet for deformation or damage.
- Check the brake pedal for bend, damage, and cracks on the welded parts.
- Check clevis pin and plastic stopper (A) for damage and deformation.
If any damage is found, replace clevis pin.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION: Replace the brake pedal if it has been dropped or sustained an impact.
- Check that the brake pedal height and brake pedal play meet the specifications by checking the brake pedal and brake booster for damage and replace parts as necessary. Refer to BR-54, "Brake Pedal".
Brake piping
FRONT
FRONT : Exploded View
Master cylinder secondary to
ABS actuator brake tube
Master cylinder primary to
ABS actuator brake tube
Brake tube bracket
Brake tube (LH)
Brake ...
Other materials:
Control cable
Exploded View
Shift selector
Control cable
Retainer grommet
Lock plate
Bracket
Manual lever
Transaxle assembly
Front
Removal and Installation
CAUTION:
Always apply the parking brake before performing removal and installation.
REMOVAL
Apply the parking ...
P0171 fuel injection system function
DTC Description
DTC DETECTION LOGIC
With the Air/Fuel Mixture Ratio Self-Learning Control, the actual mixture
ratio can be brought closely to the
theoretical mixture ratio based on the mixture ratio feedback signal from the
A/F sensors 1. The ECM calculates
the necessary compensation to corr ...
B142X collision detection
Description
DTC B1209 - B1211 COLLISION DETECTION
The air bag diagnosis sensor unit will set this DTC if it has detected a
collision which has resulted in a deployment
of one or more air bags or pre-tensioners. If this DTC is detected after a SRS
repair, the air bag diagnosis
sensor unit has ...
