Exploded View
: Apply PBC (Poly Butyl
Cuprysil) grease or silicone-based grease.
: Apply brake fluid.
Removal and Installation
REMOVAL
CAUTION:
NOTE: When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.
CAUTION: Do not scratch the flare nut or the brake pipe.
CAUTION: Do not depress the brake pedal after the master cylinder assembly is removed.
INSTALLATION
CAUTION:
Installation is in the reverse order of removal.
CAUTION: Do not scratch the flare nut or the brake pipe.
Disassembly and Assembly
DISASSEMBLY
CAUTION:
CAUTION: Always use copper plates or cloth between vise and cylinder body. Do not overtighten the vise.
CAUTION: Do not reuse the pin.
CAUTION:
ASSEMBLY
CAUTION: Do not use mineral oil such as gasoline or light oil.
CAUTION: Do not drop the parts during installation. The parts must not be reused if they are dropped.
CAUTION: Do not reuse the pin.
U110f lost communication (ECM)
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
U110F
LOST COMM (ECM)
(Lost Communication With ECM)
When the ignition switch is ON, TCM is unable to receive the CAN
communications
signal from ...
Main power window and door lock/unlock switch
Removal and Installation
REMOVAL
Remove the front door pull handle bracket (LH). Refer to INT-15,
"Removal and Installation".
Release pawls using a suitable tool (A) and remove main power
window and door lock/unlock switch finisher (1).
: Pawl
Disconnect t ...
Map lights
Map lights
Push the button to turn the map lights on. To turn
them off, press the button again.
CAUTIONDo not use for extended periods of time
with the engine stopped. This could result
in a discharged battery.
Personal Lights (if so equipped)
Rear personal lights
To tu ...