Nissan Rogue manuals

Nissan Rogue Service Manual: Brake booster

Inspection

Operation

Depress the brake pedal several times at five second intervals with the engine stopped. Start the engine with the brake pedal fully depressed. Check that the clearance between brake pedal and dash lower panel decreases.

NOTE: A slight impact with a small click may be felt on the pedal when the brake pedal is fully depressed. This is normal brake system operation.

Operation

Vacuum Inspection

Idle the engine for one minute to apply vacuum to the brake booster.

Stop the engine. Depress the brake pedal several times at five second intervals until the accumulated vacuum is released to atmospheric pressure. Check that the clearance between brake pedal and dash lower panel gradually increases (A → B → C) each time the brake pedal is depressed during this operation.

Vacuum Inspection

Depress the brake pedal with the engine running. Then stop the engine while holding down the brake pedal. Check that the brake pedal stroke does not change after holding down the brake pedal for 30 seconds or more.

NOTE: A slight impact with a small click may be felt on the pedal when the brake pedal is fully depressed. This is normal brake system operation.

Vacuum Inspection

Brake master cylinder
Inspection Check for brake fluid leakage at the following areas:  Master cylinder mounting face  Reservoir tank mounting face  Brake tube and brake tube connections  Bra ...

Front disc brake
BRAKE PAD BRAKE PAD : Inspection Check brake pad wear thickness from an inspection hole (A) on cylinder body. Check using a scale if necessary. Wear thickness : Refer to BR-55, "Front Dis ...

Other materials:

Servicing air conditioner
The air conditioner system in your NISSAN vehicle is charged with a refrigerant designed with the environment in mind. This refrigerant does not harm the earth’s ozone layer. Special charging equipment and lubricant is required when servicing your NISSAN air conditioner. Using improper ...

Valet parking mode
Principle In the valet parking mode, the Control Display is disabled. The operation via iDrive is no longer possible. E.g., this mode can be used when the vehicle is handed over for valet parking. General information In the valet parking mode, it is not possible to change vehicle settings via iDriv ...

System description
COMPONENT PARTS Component Parts Location View right of steering column. No. Component Function 1 Combination meter Combination meter transmits the vehicle speed signal to BCM via CAN communication. BCM also receives the vehicle speed signal f ...

© 2014-2022 Copyright www.nirogue.com