Nissan Rogue Service Manual: Basic inspection
CONFIGURATION (CAN GATEWAY)
Work Procedure
1.WRITING MODE SELECTION
CONSULT Configuration
Select “Re/programming, Configuration” of CAN gateway.
When writing saved data>>GO TO 2.
When writing manually>>GO TO 3.
2.PERFORM “AFTER REPLACE ECU” OF “READ / WRITE CONFIGURATION”
CONSULT Configuration
Perform “After Replace ECU” of “Read / Write Configuration”.
>> GO TO 4.
3.PERFORM “MANUAL CONFIGURATION”
CONSULT Configuration
- Select “Manual Configuration”.
- Touch “Next”.
- Touch “OK”.
- Check that the configuration has been successfully written and touch “End”.
>> GO TO 4.
4.CHECK ALL ECU SELF-DIAGNOSIS RESULTS
- Erase all ECU self-diagnosis results using CONSULT.
- Turn the ignition switch OFF.
- Turn the ignition switch ON and wait for 2 seconds or more.
- Check that all ECU self-diagnosis results have no DTC (e.g. U1000 and U1001) of CAN communication.
>> WORK END
ECU diagnosis information
CAN GATEWAY
Reference Value
VALUES ON THE DIAGNOSIS TOOL
NOTE:
The following table includes information (items) inapplicable to this vehicle.
For information (items) applicable
to this vehicle, ...
DTC/circuit diagnosis
B2600-46 CONFIG ERROR
DTC Description
DTC DETECTION LOGIC
DTC
Trouble diagnosis
(Trouble diagnosis contents)
Detecting condition
B2600-46
CONFIG ERROR
(Co ...
Other materials:
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
...
Break-in schedule
CAUTIONDuring the first 1,200 miles (2,000 km),
follow these recommendations to obtain
maximum engine performance and ensure
the future reliability and economy of your
new vehicle. Failure to follow these recommendations
may result in shortened
engine life and reduced engine ...
DTC/circuit diagnosis
U1000 CAN COMM CIRCUIT
Description
Refer to LAN-8, "System Description".
DTC Logic
DTC DETECTION LOGIC
NOTE:
U1000 can be set if a module harness was disconnected and reconnected, perhaps
during a repair. Confirm
that there are actual CAN diagnostic symptoms and a present DTC by p ...
