Nissan Rogue Service Manual: B2268 water temp
Description
The engine coolant temperature signal is transmitted from ECM to the combination meter via CAN communication.
DTC Logic
DTC DETECTION LOGIC
|
DTC |
CONSULT |
Detection Condition |
Possible Cause |
| B2268 | WATER TEMP [B2268] | ECM continuously transmits abnormal engine coolant temperature signals for 60 seconds or more. |
|
Diagnosis Procedure
1.PERFORM SELF DIAGNOSIS OF ECM
Perform "Self Diagnostic Result" of "ECM", and repair or replace malfunctioning parts.
>> Refer to EC-93, "DTC Index".
B2267 engine speed
Description
The engine speed signal is transmitted from ECM to the combination meter with
CAN communication.
DTC Logic
DTC DETECTION LOGIC
DTC
CONSULT
Detection Conditio ...
Power supply and ground circuit
COMBINATION METER
COMBINATION METER : Diagnosis Procedure
Regarding Wiring Diagram information, refer to MWI-32, "Wiring Diagram".
1.CHECK FUSES
Check that the following fuses are not bl ...
Other materials:
P1574 ASCD vehicle speed sensor
Description
The ECM receives two vehicle speed sensor signals via CAN communication line.
One is sent from combination
meter, and the other is from TCM (Transmission control module). The ECM uses
these signals for ASCD
control. Refer to EC-47, "AUTOMATIC SPEED CONTROL DEVICE (ASCD) : Sys ...
Monitor, climate, audio, phone and voice recognition systems
WARNING
Positioning of the heating or air conditioning
controls and display controls
should not be done while driving in order
that full attention may be given to
the driving operation.
Do not disassemble or modify this system.
If you do, it may result ...
Occupant classification system control unit
Removal and Installation
OCCUPANT CLASSIFICATION SYSTEM CONTROL UNIT
WARNING:
Before servicing the SRS, turn ignition switch OFF, disconnect
both battery terminals then wait at
least three minutes.
Do not use air tools or electric tools for servicing.
Removal
Re ...
