Nissan Rogue Service Manual: B142X collision detection

Nissan Rogue Service Manual / Restraints / SRS Airbag Control System / DTC/circuit diagnosis / B142X collision detection

Description

DTC B1209 - B1211 COLLISION DETECTION

The air bag diagnosis sensor unit will set this DTC if it has detected a collision which has resulted in a deployment of one or more air bags or pre-tensioners. If this DTC is detected after a SRS repair, the air bag diagnosis sensor unit has not yet been replaced. This DTC can not be erased.

PART LOCATION

Refer to SRC-6, "Component Parts Location".

DTC Logic

DTC DETECTION LOGIC

With CONSULT

CONSULT name	DTC	DTC detecting condition	Repair order
FRONTAL COLLISION DETECTION	B1421	Frontal collision detected. Driver and/or front passenger air bag modules are deployed.	Refer to SR-5, "FOR FRONTAL COLLISION : When SRS is activated in a collision" or SR-6, "FOR FRONTAL COLLISION : When SRS is not activated in a collision".
SIDE COLLISION DETECTION	B1422	Side collision detected. Curtain air bag module and seat belt pre-tensioner are deployed	Refer to SR-7, "FOR SIDE AND ROLLOVER COLLISION : When SRS is activated in a collision" or SR-8, "FOR SIDE AND ROLLOVER COLLISION : When SRS is not activated in a collision"

DTC CONFIRMATION PROCEDURE (With CONSULT)

1.INSPECTION START

Turn ignition switch ON.

>> GO TO 2.

2.CHECK SELF-DIAG RESULT

Check for the DTC on CONSULT.

Is the DTC detected? YES >> Refer to SRC-97, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

Refer to Frontal collision: SR-5, "FOR FRONTAL COLLISION : When SRS is activated in a collision", SR-6, "FOR FRONTAL COLLISION : When SRS is not activated in a collision" or SR-7, "FOR SIDE AND ROLLOVER COLLISION : When SRS is activated in a collision" or Side and rollover collision: SR-8, "FOR SIDE AND ROLLOVER COLLISION : When SRS is not activated in a collision"

U1010 control unit (CAN)

Description Air bag diagnosis sensor performs self-tests on key ON. If CAN communication failure within control unit is detected, DTC is set. DTC Logic DTC DETECTION LOGIC CONSULT na ...

Symptom diagnosis

...

Other materials:

Filament
Inspection and Repair INSPECTION When measuring voltage, wrap tin foil around the top of the negative probe. Then press the foil against the wire with your finger. Attach probe circuit tester (in Volt range) to middle portion of each filament. If a filament is b ...

Easy fill tire alert does not activate
Description The easy fill tire alert does not function while inflating a tire when the select lever position is in P-range with the power switch ON or with the vehicle set to READY. NOTE: After starting to inflate the tire, it takes a few seconds for the easy fill tire alert to fun ...

C1121, C1123, C1125, C1127 ABS out valve system
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1121 FR LH OUT ABS SOL When a malfunction is detected in front LH ABS OUT valve. Harness or connector ABS actuator and electric unit (control u ...