Nissan Rogue manuals

Nissan Rogue Service Manual: Auto operation does not operate

MOONROOF

MOONROOF : Diagnosis Procedure

1. PERFORM INITIALIZATION PROCEDURE

Perform initialization procedure.

Refer to RF-24, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement".

Is the inspection result normal? YES >> Moonroof system is normal.

NO >> GO TO 2.

2.CHECK MOONROOF SWITCH

Check moonroof switch.

Refer to RF-31, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace the malfunctioning parts.

3.CONFIRM THE OPERATION

Confirm the operation again.

Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-41, "Intermittent Incident".

NO >> GO TO 1.

SUNSHADE

SUNSHADE : Diagnosis Procedure

1.PERFORM INITILAZATION PROCEDURE

Refer to RF-24, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement".

Is the inspection result normal? YES >> Sunshade system is normal.

NO >> GO TO 2.

2.CHECK MOONROOF SWITCH

Check moonroof switch.

Refer to RF-31, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace the malfunctioning parts.

3.CONFIRM THE OPERATION

Confirm the operation again.

Is the result normal? YES >> Check intermittent incident. Refer to GI-41, "Intermittent Incident".

NO >> GO TO 1.

Sunshade system does not operate properly
Diagnosis Procedure 1.CHECK BCM POWER SUPPLY AND GROUND CIRCUIT Check BCM power supply and ground circuit. Refer to BCS-68, "Diagnosis Procedure" (with Intelligent Key System), BCS-128, ...

Anti-pinch function does not operate
MOONROOF MOONROOF : Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to RF-24, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repai ...

Other materials:

Basic inspection
DIAGNOSIS AND REPAIR WORK FLOW Work flow OVERALL SEQUENCE DETAILED FLOW 1.OBTAIN INFORMATION ABOUT SYMPTOM Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred. >> GO TO 2. 2.CHECK SYMPTOM ...

Water outlet and water piping
Exploded View Water outlet Water temperature sensor Water outlet O-ring  Clamp Heater pipe O-ring Heater pipe  Water hose  Refer to INSTALLATION Removal and Installation WARNING: Do not remove the radiator cap when the engine is hot. Serious burns c ...

P0779 pressure control solenoid B
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0779 Pressure control solenoid B Inte When all of the following conditions are satisfied and this state is maintained for 0.2 seconds:  T ...

В© 2014-2022 Copyright www.nirogue.com