Nissan Rogue manuals

Nissan Rogue Owners Manual: Air cleaner

Air cleaner
Air cleaner

The air cleaner filter should not be cleaned and reused. Replace it according to the maintenance log shown in the “NISSAN Service and Maintenance Guide.” To remove the air cleaner filter:

  1.  Unlatch the retaining clips A .
  2.  Pull up at points B and remove.
  3.  Pull up and remove air cleaner housing C .
  4.  Remove the air cleaner filter. Wipe the inside of the air cleaner filter housing and the cover with a damp cloth, then replace air cleaner filter.

NOTE: After installing a new air cleaner, make sure the air cleaner cover is seated in the housing and latch the clips.

WARNING
  •  Operating the engine with the air cleaner removed can cause you or others to be burned. The air cleaner not only cleans the air, it stops the flame if the engine backfires. If it isn’t there, and the engine backfires, you could be burned. Do not drive with the air cleaner removed, and be careful when working on the engine with the air cleaner removed.
  •  Never pour fuel into the throttle body or attempt to start the engine with the air cleaner removed. Doing so could result in serious injury.

IN-CABIN MICROFILTER

The in-cabin microfilter restricts the entry of airborne dust and pollen particles and reduces some objectionable outside odors. The filter is located behind the glove box. Refer to the “NISSAN Service and Maintenance Guide” for change intervals.

If replacement is required, see your NISSAN dealer.

Spark plugs
Replacing spark plugs Platinum-tipped spark plugs It is not necessary to replace platinum-tipped A spark plugs as frequently as conventional type spark plugs because they last much longer. Fol ...

Windshield wiper blades
Cleaning If your windshield is not clear after using the windshield-washer or if a wiper blade chatters when running, wax or other material may be on the blade or windshield. Clean the outside ...

Other materials:

Ignition signal
Component Function Check 1.INSPECTION START Turn ignition switch OFF, and restart engine. Does the engine start? YES-1 >> With CONSULT: GO TO 2. YES-2 >> Without CONSULT: GO TO 3. NO >> Proceed to EC-470, "Diagnosis Procedure". 2.CHECK IGNITION SIGNAL FUNCTIO ...

Adjust
For adjustable head restraint/headrest Adjust the head restraint/headrest so the center is level with the center of your ears. If your ear position is still higher than the recommended alignment, place the head restraint/headrest at the highest position. For non-adjustable head restraint ...

P1148 closed loop control
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P1148 CLOSED LOOP-B1 (CLOSED LOOP-B1) The closed loop control function does not operate even when vehicle is being driven in the specified c ...

© 2014-2025 Copyright www.nirogue.com