Description
Perform the following work after the transaxle assembly is replaced.
WRITING TCM DATA
ERASING OF CVT FLUID DEGRADATION LEVEL DATA
Work Procedure
1.CHECK THE SERIAL NUMBER
Write down the serial number of new transaxle assembly.
>> GO TO 2.
2.WRITE TCM DATA (IP CHARACTERISTICS VALUE)
NOTE: Write data of new solenoid in TCM according to the following instructions:
With CONSULT
CAUTION: When the work is interrupted, obtain data again from the supplied CD.
NOTE: When writing is complete, the shift position indicator of the combination meter displays P.
>> GO TO 3.
3.ERASE CVT FLUID DEGRADATION LEVEL DATA
With CONSULT
>> WORK END
Removal and installation
A/C SWITCH ASSEMBLY
Removal and Installation
REMOVAL
Release the A/C switch assembly clips and pawls using a suitable
tool.
: Metal clip
: Pawl
Disconnect the harness connector from the A/C switch assembly
(1) and remove.
INSTALLATION
Installation is in the reve ...
Air cleaner
Air cleaner
The air cleaner filter should not be cleaned and
reused. Replace it according to the maintenance
log shown in the “NISSAN Service and Maintenance
Guide.”
To remove the air cleaner filter:
Unlatch the retaining clips A .
Pull up at points B and remove.
  ...
ECU diagnosis information
AUTOMATIC BACK DOOR CONTROL UNIT
Reference Value
VALUES ON THE DIAGNOSIS TOOL
CONSULT MONITOR ITEM
TERMINAL LAYOUT
PHYSICAL VALUES
Fail Safe
DTC Inspection Priority Chart
If some DTCs are displayed at the same time, perform inspections one by one
based on th ...