Description
When replacing TCM and transaxle assembly simultaneously, perform the following work.
TCM PROGRAMMING
CAUTION: When replacing TCM, save TCM data on CONSULT before removing TCM.
WRITING TCM DATA
Work Procedure
1.SAVE TCM DATA (VEHICLE SPECIFICATIONS)
With CONSULT
NOTE: If “AT/CVT” is not displayed and TCM data cannot be saved on CONSULT, GO TO 2.
>> GO TO 2.
2.REPLACE TCM AND TRANSAXLE ASSEMBLY
>> GO TO 3.
3.WRITE TCM DATA (VEHICLE SPECIFICATIONS)
With CONSULT
>> GO TO 4.
4.CHECK THE SERIAL NUMBER
Write down the serial number of new transaxle assembly.
>> GO TO 5.
5.WRITE TCM DATA (IP CHARACTERISTICS VALUE)
NOTE: Write data of new solenoid in TCM according to the following instructions:
With CONSULT
CAUTION: When the work is interrupted, obtain data again from the supplied CD.
NOTE: When writing is complete, the shift position indicator of the combination meter displays P.
>> WORK END
Unit disassembly and assembly
TRANSFER COVER
Exploded View
Filler plug
Gasket
Drain plug
Oil seal
Transfer cover
Oil seal
O-ring
Ring gear bearing adjusting shim
(transfer cover side)
Ring gear bearing (transfer cover
side)
Ring gear shaft oil seal
...
Additional service when replacing transaxle assembly
Description
Perform the following work after the transaxle assembly is replaced.
WRITING TCM DATA
TCM performs accurate control by retrieving data (inherent
characteristic value) of each solenoid. For this
reason, after replacing transaxle assembly, it is necessary to write new
d ...
Key interlock cable
Exploded View
Key cylinder
Clip
Key interlock cable
Shift selector assembly
Removal and Installation
REMOVAL
CAUTION:
Always apply the parking brake before performing removal and installation.
Move shift selector to the “N” position.
Remo ...