Nissan Rogue Service Manual: Additional service when replacing TCM
Description
Always perform the following items when the TCM is replaced.
TCM PROGRAMMING
- Since vehicle specifications are not yet written in a new TCM, it is necessary to write them with CONSULT.
CAUTION: When replacing TCM, save TCM data on CONSULT before removing TCM.
SAVING AND WRITING OF TCM DATA
- TCM performs accurate control by retrieving data (inherent characteristic value) of each solenoid. For this reason, it is necessary to save data of current TCM in CONSULT before replacing the TCM. After this, the saved data must be written in new TCM.
Work Procedure
1.SAVE TCM DATA (IP CHARACTERISTICS VALUE)
NOTE: Save necessary data stored in TCM in CONSULT according to the following instructions:
With CONSULT
- Turn ignition switch OFF and wait for 10 seconds.
- Turn ignition switch ON.
- Select “Work Support” in “TRANSMISSION”.
- Select “READ IP CHARA - REPLACEMENT TCM”.
- Import data according to the instructions on the CONSULT screen.
>> GO TO 2.
2.SAVE TCM DATA (VEHICLE SPECIFICATIONS)
With CONSULT
- Turn ignition switch OFF.
- Turn ignition switch ON.
- Select “Re/programming, Configuration”.
- Select “AT/CVT”.
NOTE: If “AT/CVT” is not displayed and TCM data cannot be saved on CONSULT, GO TO 3.
- Select “Programming”.
- Save TCM data on CONSULT according to the CONSULT display.
>> GO TO 3.
3.REPLACE TCM
- Turn ignition switch OFF and wait for 10 seconds.
- Replace TCM. Refer to TM-202, "Removal and Installation".
>> GO TO 4.
4.WRITE TCM DATA (VEHICLE SPECIFICATIONS)
With CONSULT
- Select “Programming”.
- Perform programming according to the CONSULT display.
>> GO TO 5.
5.WRITE TCM DATA (IP CHARACTERISTICS VALUE)
NOTE: Write data saved in CONSULT into a new TCM according to the following instructions:
With CONSULT
- Turn ignition switch OFF and wait for 10 seconds.
- Turn ignition switch ON.
- Select “Work Support” in “TRANSMISSION”.
- elect “WRITE IP CHARA - REPLACEMENT TCM”.
- Write data saved in CONSULT in TCM according to the instructions on the CONSULT screen.
>> WORK END
Diagnosis and repair work flow
Work Flow
NOTE:
“DTC” includes DTC at the 1st trip.
1.OBTAIN INFORMATION ABOUT SYMPTOM
Refer to TM-80, "Diagnostic Work Sheet" and interview the customer to obtain
the malfunction ...
Additional service when replacing transaxle assembly
Description
Perform the following work after the transaxle assembly is replaced.
WRITING TCM DATA
TCM performs accurate control by retrieving data (inherent
characteristic value) of eac ...
Other materials:
Driver air bag module
Exploded View
Steering wheel
Driver air bag module
Removal and Installation
WARNING:
Before servicing the SRS, turn ignition switch OFF, disconnect
both battery terminals then wait at
least three minutes.
Always work from the side of driver air bag module. Do no ...
P0182, P0183 FTT sensor
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P0182
FTT SEN/CIRCUIT
(Fuel temperature sensor ″A″ circuit low)
An excessively low voltage from the sensor is sent to ECM.
P01 ...
S connector circuit
Description
The starter motor magnetic switch is supplied with power when the ignition
switch is turned to the START position
while the selector lever is in the P (Park) or N (Neutral) position.
Diagnosis Procedure
Regarding Wiring Diagram information, refer to STR-7, "Wiring Diagram" ...
