Nissan Rogue manuals

Nissan Rogue Service Manual: U0073 communication bus a OFF

DTC Description

DTC DETECTION LOGIC

DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition
U0073 COMM BUS A OFF (Control Module Communication Bus A Off) TCM communication blockage lasts for 2 seconds or more when turning ON the ignition switch. (Communication not established.)

POSSIBLE CAUSE

Harness or connector (CAN communication line is error)

FAIL-SAFE

DTC CONFIRMATION PROCEDURE

1.PREPARATION BEFORE WORK

If another “DTC CONFIRMATION PROCEDURE” occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

  1.  Start the engine and wait for at least 5 seconds.
  2.  Check the DTC.

Is “U0073” detected? YES >> Go to TM-95, "Diagnosis Procedure".

NO-1 >> To check malfunction symptom before repair: Refer to GI-41, "Intermittent Incident".

NO-2 >> Confirmation after repair: INSPECTION END

Diagnosis Procedure

For the diagnosis procedure, refer to LAN-17, "Trouble Diagnosis Flow Chart".

Dtc/circuit diagnosis
...

U0100 lost communication (ECM A)
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U0100 LOST COMM (ECM A) (Lost Communication With ECM/P ...

Other materials:

Unit disassembly and assembly
COMBINATION METER Exploded View Combination meter Combination meter lens Pawl Disassembly and Assembly CAUTION:  Do not touch the display, pointer, inside of combination meter or the printed area of the dial during disassembly or assembly.  Keep away from magn ...

How to check terminal
CONNECTOR AND TERMINAL PIN KIT  Use the connector and terminal pin kits listed below when replacing connectors or terminals.  The connector and terminal pin kits contain some of the most commonly used NISSAN/INFINITI connectors and terminals. For detailed connector and termin ...

P0705 transmission range sensor A
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0705 T/M RANGE SENSOR A [Transmission Range Sensor A Circuit (PRNDL Input)] When all of the following conditions are satisfied and this state is ...

© 2014-2025 Copyright www.nirogue.com