WITH MANUAL A/C
WITH MANUAL A/C : Description
WITH MANUAL A/C : Component Function Check
1. CHECK REAR WINDOW DEFOGGER SWITCH FUNCTION
Check that the indicator lamp of the rear window defogger switch illuminates when rear window defogger switch is ON.
Is the inspection result normal? YES >> Rear window defogger switch function is OK.
NO >> Refer to DEF-22, "WITH MANUAL A/C : Diagnosis Procedure".
WITH MANUAL A/C : Diagnosis Procedure
Regarding Wiring Diagram information, refer to DEF-12, "Wiring Diagram".
1.CHECK REAR WINDOW DEFOGGER SWITCH OPERATION
With CONSULT
Is the inspection result normal? YES >> Rear window defogger switch is OK.
NO >> Replace front air control. Refer to HAC-181, "Removal and Installation".
WITH AUTO A/C
WITH AUTO A/C : Description
WITH AUTO A/C : Component Function Check
1. CHECK REAR WINDOW DEFOGGER SWITCH FUNCTION
Check that the indicator lamp of the rear window defogger switch illuminates when rear window defogger switch is ON.
Is the inspection result normal? YES >> Rear window defogger switch function is OK.
NO >> Refer to DEF-22, "WITH MANUAL A/C : Diagnosis Procedure".
WITH AUTO A/C : Diagnosis Procedure
Regarding Wiring Diagram information, refer to DEF-12, "Wiring Diagram".
1.CHECK REAR WINDOW DEFOGGER SWITCH OPERATION
With CONSULT
Is the inspection result normal? YES >> Rear window defogger switch is OK.
NO >> Replace A/C switch. Refer to HAC-102, "Removal and Installation".
Forward-facing child restraint installation
using the seat belts
WARNINGThe three-point seat belt with Automatic
Locking Retractor (ALR) must be used
when installing a child restraint. Failure to
use the ALR mode will result in the child
restraint not being properly secured. The
restraint could tip over or be loose and
cause injury to a c ...
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
...
Filament
Inspection and Repair
INSPECTION
When measuring voltage, wrap tin foil around the top of the
negative
probe. Then press the foil against the wire with your finger.
Attach probe circuit tester (in Volt range) to middle portion of
each filament.
If a filament is b ...