Nissan Rogue manuals

Nissan Rogue Service Manual: Front wiper motor lo circuit

Nissan Rogue Service Manual / Driver controls / Wiper & Washer / DTC/circuit diagnosis / Front wiper motor lo circuit

Component Function Check

1.CHECK FRONT WIPER LO OPERATION

CONSULT ACTIVE TEST

  1.  Select FR WIPER of BCM (WIPER) active test item.
  2.  Check front wiper operation.

LO : Front wiper (LO) operation
OFF : Front wiper OFF

Is the inspection result normal? YES >> Front wiper motor LO circuit is normal.

NO >> Refer to WW-36, "Diagnosis Procedure".

Diagnosis Procedure

Regarding Wiring Diagram information, refer to WW-22, "Wiring Diagram".

1. CHECK FRONT WIPER MOTOR FUSE

  1.  Turn the ignition switch OFF.
  2.  Check that the following fuse is not blown.

Check front wiper motor fuse

Is the fuse blown? YES >> Replace the fuse after repairing the affected circuit.

NO >> GO TO 2.

2. CHECK FRONT WIPER MOTOR (LO) OUTPUT VOLTAGE

  1.  Turn the ignition switch ON.
  2.  Select FR WIPER of BCM (WIPER) active test item.
  3.  While performing the active test, check voltage between IPDM E/R harness connector and ground.

Check front wiper motor (lo) output voltage

Is the inspection result normal? YES >> GO TO 3.

NO >> Replace IPDM E/R. Refer to PCS-35, "Removal and Installation".

3. CHECK FRONT WIPER MOTOR (LO) OPEN CIRCUIT

  1.  Turn the ignition switch OFF.
  2.  Disconnect IPDM E/R and front wiper motor.
  3.  Check continuity between IPDM E/R harness connector and front wiper motor harness connector.

Check front wiper motor (lo) open circuit

Is the inspection result normal? YES >> Replace front wiper motor. Refer to WW-67, "Removal and Installation".

NO >> Repair or replace harness.

Wiper and washer fuse
Description Diagnosis Procedure 1. CHECK FUSES Check that the following fuses are not blown. Is the fuse blown? YES >> Replace the fuse after repairing the affected circuit. NO & ...

Front wiper motor HI circuit
Component Function Check 1.CHECK FRONT WIPER HI OPERATION CONSULT ACTIVE TEST  Select FR WIPER of BCM (WIPER) active test item.  Check front wiper operation. HI : Front wiper (HI ...

Other materials:

Connector Symbols
Most of connector symbols in wiring diagrams are shown from the terminal side.  Connector symbols shown from the terminal side are enclosed by a single line and followed by the direction mark.  Connector symbols shown from the harness side are enclosed by a double line and foll ...

C1121, C1123, C1125, C1127 ABS out valve system
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1121 FR LH OUT ABS SOL When a malfunction is detected in front LH ABS OUT valve. Harness or connector  ABS actuator and electric unit (control u ...

Hill Descent Control System (if so equipped)
Hill Descent Control System WARNING  Never rely solely on the hill descent control system to control vehicle speed when driving on steep downhill grades. Always drive carefully and attentively when using the hill descent control system and decelerate the vehi ...

В© 2014-2025 Copyright www.nirogue.com