Nissan Rogue manuals

Nissan Rogue Owners Manual: Flat towing for front wheel drive vehicle (if so equipped)

Nissan Rogue Owners Manual / Technical and consumer information / Towing a trailer / Flat towing for front wheel drive vehicle (if so equipped)

Towing your vehicle with all four wheels on the ground is sometimes called flat towing. This method is sometimes used when towing a vehicle behind a recreational vehicle, such as a motor home.

CAUTION
  •  Failure to follow these guidelines can result in severe transmission damage.
  •  Whenever flat towing your vehicle, always tow forward, never backward.
  •  DO NOT tow your front wheel drive continuously variable transmission vehicle with all four wheels on the ground (flat towing). Doing so WILL DAMAGE internal transmission parts due to lack of transmission lubrication.
  •  For emergency towing procedures refer to “Towing recommended by NISSAN” in the “In case of emergency” section of this manual.

Continuously Variable Transmission

To tow a vehicle equipped with a continuously variable transmission, an appropriate vehicle dolly MUST be placed under the towed vehicle’s drive wheels. Always follow the dolly manufacturer’s recommendations when using their product.

Flat towing for All–Wheel drive vehicle (if so equipped)
Towing your vehicle with all four wheels on the ground is sometimes called flat towing. This method is sometimes used when towing a vehicle behind a recreational vehicle, such as a motor home. ...

Uniform tire quality grading
DOT (Department of Transportation) Quality Grades: All passenger car tires must conform to federal safety requirements in addition to these grades. Quality grades can be found where applicable o ...

Other materials:

System description
COMPONENT PARTS Component Parts Location Right rear wheel area Instrument panel Engine compartment Left side of instrument panel (view with trim panel removed) No. Part Function 1 Optical sensor Refer to EXL-10, "Optical Sensor" ...

Fuel pressure
Work Procedure FUEL PRESSURE RELEASE 1.FUEL PRESSURE RELEASE With CONSULT  Turn ignition switch ON.  Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode of “ENGINE” using CONSULT.  Start engine.  After engine stalls, crank it two or three times to ...

Checking engine oil level
Checking engine oil level Park the vehicle on a level surface and apply the parking brake.  Start the engine and let it idle until it reaches operating temperature.  Turn off the engine. Wait more than 10 minutes for the oil to drain back into the oil pan.  Remov ...

© 2014-2025 Copyright www.nirogue.com