Nissan Rogue Owners Manual: Operating tips
CAUTION
- Do not use alcohol, benzine or thinner
to clean the camera. This will cause
discoloration. To clean the camera,
wipe with a cloth dampened with a diluted
mild cleaning agent and then wipe
with a dry cloth.
- Do not damage the camera as the monitor
screen may be adversely affected.
|
- The screen displayed on the Around View
Monitor will automatically return to the previous
screen 3 minutes after the CAMERA
button has been pressed with the shift lever
in a position other than the R (Reverse)
position.
- When the view is switched, the display images
on the screen may be displayed in
some delay.
- When the temperature is extremely high or
low, the screen may not display objects
clearly. This is not a malfunction.
- When strong light directly shines on the
camera, objects may not be displayed
clearly. This is not a malfunction.
- The screen may flicker under fluorescent
light. This is not a malfunction.
- The colors of objects on the Around View
Monitor may differ somewhat from the actual
color of objects. This is not a malfunction.
- Objects on the Around View Monitor may
not be clear and the color of the object may
differ in a dark environment. This is not a
malfunction.
- There may be differences in sharpness between
each camera view of the bird’s-eye
view.
- If dirt, rain or snow accumulates on the camera,
the Around View Monitor may not display
objects clearly. Clean the camera.
- Do not use wax on the camera lens. Wipe off
any wax with a clean cloth that has been
dampened with a mild detergent diluted with
water.
The MOD system can inform the driver of moving
objects behind the vehicle when backing out of
garages, maneuvering in parking lots and in other
such instances.
The MOD system detects moving obje ...
Side
Adjust air flow direction by moving the vent
slides.
Open or close the vents by using the dial. Move
the dial toward the to open the
vents or
toward the to close them.
Center
Re ...
Other materials:
DTC/circuit diagnosis
U1000 CAN COMM CIRCUIT
Description
Refer to LAN-8, "System Description".
DTC Logic
DTC DETECTION LOGIC
NOTE:
U1000 can be set if a module harness was disconnected and reconnected, perhaps
during a repair. Confirm
that there are actual CAN diagnostic symptoms and a present DTC by p ...
Periodic maintenance
REAR DIFFERENTIAL GEAR OIL
Inspection
OIL LEAKS
Make sure that oil is not leaking from final drive assembly or around it.
OIL LEVEL
Remove filler plug (1) and check oil level from filler plug
mounting
hole as shown.
CAUTION:
Do not start engine while checking oil level.
&nbs ...
EPS warning lamp
Component Function Check
1.CHECK THE ILLUMINATION OF THE EPS WARNING LAMP
Check that the EPS warning lamp turns ON when ignition switch turns ON. Then,
EPS warning lamp turns
OFF after the engine is started.
Is the inspection result normal?
YES >> Inspection End.
NO >> Perfor ...
© 2014-2024 Copyright www.nirogue.com