Component Function Check
1.CHECK INFORMATION DISPLAY
CAUTION: Always drive vehicle at a safe speed.
Is the inspection result normal? YES >> INSPECTION END
NO >> Proceed to EC-475, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK DTC
Check that DTC UXXXX, P0500 or P1574 is not displayed.
Is the inspection result normal? YES >> GO TO 2.
NO-1 >> Perform trouble diagnosis for DTC UXXXX.
NO-2 >> Perform trouble diagnosis for DTC P0500. Refer to EC-350, "DTC Description".
NO-3 >> Perform trouble diagnosis for DTC P1574. Refer to EC-414, "DTC Description".
2.CHECK DTC WITH COMBINATION METER
Refer to MWI-21, "CONSULT Function (METER/M&A)".
Is the inspection result normal? YES >> GO TO 3.
NO >> Perform trouble diagnosis for DTC indicated.
3.CHECK INTERMITTENT INCIDENT
Perform GI-41, "Intermittent Incident".
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-82, "Removal and Installation".
NO >> Repair or replace error-detected parts.
Front door finisher
Exploded View
Front door
Front door pull handle bracket
Front door pull handle
Front power window switch (RH)
finisher
Front door inside handle finisher
Front door finisher
Clip
Pawl
REMOVAL
NOTE:
LH shown, RH similar.
Release pawls using a suitable tool (A) from ...
Warning lights
For additional information on warnings and indicators,
refer to “Vehicle information display” in
this section.
Anti-lock
Braking System (ABS) warning lig
When the ignition switch is placed in the ON
position, the ABS warning light illuminates and
then turns off. This indicates the ...
Removal and installation
BCM (BODY CONTROL MODULE)
Removal and Installation
For removal and installation of the BCM (Body Control Module), refer to
BCS-75, "Removal and Installation".
PUSH-BUTTON IGNITION SWITCH
Removal and Installation
REMOVAL
Remove NATS antenna amp. Refer to SEC-110, "Remo ...